User manual WHIRLPOOL HDN P600 S INSTALLATION

[. . . ] Packing Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. [. . . ] All other maintenance services must be carried out by a specialised technician. When drilling the wall, make sure not to damage the electrical connections and/or pipes. The ventilation ducts must always discharge to the outside. The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: • the type of fault, • the product model given on the dataplate inside the hood, visible on removing the grease filters, • your full address, • your telephone number and area code, • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. AFTER-SALES SERVICE Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?If the hood is not extracting enough: • Is the right speed selected?• Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? 5019 618 33096/A D GB F I LI24WA The hood is designed for use in “Extractor version” or in “Filter version” Extractor Version (see symbol in the installation handbook) Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood coupling ring. Depending on the exhaust pipe purchased, provide for suitable fixing to the coupling ring. [. . . ] Press the button to select the power/speed. Keep the button pressed for 2 seconds to switch OFF. 1 2 4 1. Grease filter Light Steam deflector Telescopic flue 3 3 Fig. 1 f1 Lamp maintenance 1. Disconnect the hood from the power supply. [. . . ]