User manual WHIRLPOOL HDN P800 S INSTRUCTION FOR USE

[. . . ] For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. WARNING: To reduce the risk of accidents, electric shock, injury or damage, when using the hood comply with the basic precautions, including the following. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. Installation must be carried out by a specialised technician, in compliance with the manufacturer’s instructions and local safety regulations. [. . . ] Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. Before installing or using the hood, carefully read and follow the instructions given in this handbook and in the enclosed installation handbook. WARNING: Be sure to observe the minimum installation distance from cookers, which is indicated in the installation handbook. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. 5019 618 33085/A LI25DA The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING: Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. the packing materials (plastic bags , polystyrene , etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood has not been damaged during transport. Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. [. . . ] Perimeter extraction panel maintenance: Clean the perimeter extraction panel as often as the grease filter, using a cloth and a not too concentrated liquid detergent. Removing the perimeter extraction panel: Pull the panel firmly towards you Fig. Hold the panel with both hands when you remove it or replace it, to prevent it from falling and causing damage or injury. Fitting the perimeter extraction panel: Refit the panel and secure it using the fastening pins located on the surface of the hood. [. . . ]