User manual WHIRLPOOL HDN SI810 PROGRAM CHART

[. . . ] Disposal must be carried out in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact your competent local office, the household waste collection service or the shop where you purchased the appliance. Electrical connection The mains power supply must match the voltage given on the appliance rating plate located inside the hood. If provided with a plug, connect the hood to a power socket complying with current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the socket is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. [. . . ] Do not use flammable materials to duct the extracted air. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. The air extracted by the hood must not be removed through the flue of the heating system or other appliances that use gas or other fuels. The room must be adequately ventilated when the hood is used together with appliances operating on gas or other fuels. Make sure lamps are cold before touching them. The discharge air must not be ducted in a flue used for removing fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All national regulations on air discharge must be observed. The hood is not a shelf, therefore do not overload or place objects on it. Note: Always wear work gloves for all installation and maintenance operations. • AFTER-SALES SERVICE Before calling the After-Sales Service 1. See if you can eliminate the problem on your own (see ”Troubleshooting guide”). Switch the hood off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: • the type of problem, • the product model given on the dataplate inside the hood, visible on removing the grease filters. • your full address, • your telephone number and area code. • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. 5019 618 33090 GB LI243A The hood is designed for use in “Extractor version” or in “Filter version” Extractor version (see symbol in the installation handbook) Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood coupling ring. Depending on the exhaust pipe purchased, provide for suitable fixing to the coupling ring. Important: If already installed, remove the carbon filter/s. Filter version (see symbol in the installation handbook) Air is filtered through the carbon filter/s and recycled into the surrounding environment. Important: Ensure that air recirculation is facilitated (carefully follow the instructions given in the installation handbook) Important! [. . . ] 2 Grease filters: The metal grease filter has an unlimited life and must be washed once a month by hand or in a dishwasher at a low temperature and with short cycle. Washing in a dishwasher can cause the grease filter to become opaque, but its filtering capacity is not affected. Grease filter maintenance: 1. Disconnect the hood from the power supply. to remove it/them pull the spring release handle backwards (f1) then remove the filter/s downwards (f2) Carbon filter maintenance (for models with filter installation): The carbon filter must be washed once a month in a dishwasher at the highest temperature, using a normal dishwasher detergent. [. . . ]