User manual WHIRLPOOL HDN SI840 INSTRUCTION FOR USE

[. . . ] AVVERTENZA: Rispettare la distanza minima di installazione dai fuochi indicata sul libretto di installazione. Se le istruzioni di installazione del dispositivo di cottura a gas specificano una distanza maggiore, bisogna tenerne conto. 5019 618 33091/A LI246A SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. [. . . ] All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. 5019 618 33091/A D GB F I LI246A The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING: Failure to remove oil/grease (at least once a month) could result in fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Make sure the hood has not been damaged during transport. Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. [. . . ] Close the lighting unit (snap-on). f1 f2 Fig. 2 Grease filters: The metal grease filter has an unlimited life and must be washed once a month by hand or in a dishwasher at a low temperature and with short cycle. Washing in a dishwasher can cause the grease filter to become opaque, but its filtering capacity is not affected. Grease filter maintenance: 1. Disconnect the hood from the power supply. [. . . ]