User manual WHIRLPOOL HDN SW640 INSTALLATION

[. . . ] The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. [. . . ] The Manufacturer declines any liability for improper use or incorrect setting of the controls. IMPORTANT INSTRUCTIONS FOR SAFETY 12. The appliance is not intended for use by children or persons with limited physical, sensory or mental abilities or without experience and knowledge of it, unless they are under the supervision of or instructed in its use by a person responsible for their safety. To reduce the risk of fire, only use a metal inlet duct. Children must be supervised so that they do not play with the appliance. The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not “flambé” food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. Specify: • the type of fault, • the product model given on the dataplate inside the hood, visible on removing the grease filters, • your full address, • your telephone number and area code, • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. AFTER-SALES SERVICE Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?If the hood is not extracting enough: • Is the right speed selected?• Do the filters need cleaning or replacing?If the lamp does not work: • Does the lamp need replacing?• Is the lamp correctly fitted? 5019 618 33093/A D GB F I LI25RA The hood is designed for use in “Extractor version” or in “Filter version” Extractor version (see symbol in installation handbook) fumes are extracted and expelled to the outside through a fumes exhaust hose (not supplied) fixed to the collar of the hood. In accordance with the exhaust hose purchased, provide a suitable fixing system to secure it to the collar. Warning: If already installed, remove the carbon filter/s. Filter version (see symbol in installation handbook) Air is filtered through a carbon filter/s and recycled into the surrounding environment. Warning: check that air recirculation is facilitated (to this end, carefully follow the instructions given in the installation handbook) Warning! [. . . ] Use a small screwdriver or any other suitable tool to prise off the lamp cover (Fig. 1). Use G4 20W max halogen bulbs only, taking care not to touch them with your hands. Close the lighting unit (snap-on). Perimeter extraction panel maintenance: Clean the perimeter extraction panel as often as the grease filter, using a cloth and a not too concentrated liquid detergent. Removing the perimeter extraction panel: Pull the panel firmly towards you Fig. 2. [. . . ]