User manual WHIRLPOOL HDN SW840 INSTALLATION

[. . . ] The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket. Do not pull the power supply cable in order to unplug the appliance. The electrical components must not be accessible to the user after installation. Do not touch the appliance with any wet part of the body and do not operate it when barefoot. [. . . ] WARNING: when the hob is in use, accessible parts of the hood may become hot. Installation and connection After unpacking the appliance, check for any transport damage. In the event of problems, contact the After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. Preparing for installation WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people. The minimum distance between the hob and the bottom part of the hood must not be less than 65 cm for gas cookers and 50cm for electric cookers. Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed. Electrical connection Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information can be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. iMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. € Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. ENGLISH 8 Perimeter extraction panel maintenance: Clean the perimeter extraction panel as often as the grease filter, using a cloth and a not too concentrated liquid detergent. Removing the perimeter extraction panel: Pull the panel firmly towards you. Unplug the appliance or disconnect the power supply. Remove the grease filters: pull the spring release handle, then remove the filter downwards. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. WARNING: Hold the panel with both hands when you remove it or replace it, to prevent it from falling and causing damage or injury. Fitting the perimeter extraction panel: Refit the panel and secure it using the fastening pins located on the surface of the hood. WARNING: Always check to ensure that the panel is firmly fixed in place. [. . . ] eNGLISH 12 Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. Scrapping the product - This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). - By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]