User manual WHIRLPOOL HDW 8000/PRO INSTALLATION

[. . . ] Curtains and delicate clothing, dresses, skirts, shirts and blouses. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable. This programme is tested and approved by The Woolmark Company for machine- and handwashable wool. Select spin speed according to the manufacturer’s recommendations on the care label. [. . . ] • Press the Start delay button to select a delay time up to 23 hours. • Press the “Start (Pause)” button . The clock symbol next to the delay time and the colon between hours and minutes blink. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • If you use the “Dosing Aid” button: select the delay time BEFORE pressing the “Dosing Aid” button. The countdown of the selected delay time begins after having pressed the “Start (Pause)” button for the second time (see separate Instructions for Use concerning the “Dosing Aid”). To cancel the “Start delay” . . . before you press the “Start (Pause)” button: • Press the “Reset/Drain” button , or set the start delay time to “0:00” - the delay time disappears after a few seconds. . . . after having started the programme: - the delay time - Press the “Start (Pause)” button disappears from the display. Press “Start (Pause)” again to start the selected programme immediately. change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock, proceed in the same way as for activating it. FAILURE INDICATIONS If one of the failure indications on the display lights up, refer to the “Troubleshooting Guide” in your “Instructions for Use”. PROGRAMME END • The display shows “End”, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. • Leave the door ajar to allow the drum to dry. • If you do not turn the programme selector to the “Off/O” position, all lights of the control panel go out after a few minutes to save energy - only “End” will remain on the display. DETERGENT OVERDOSAGE INDICATION The symbol will light up at the end of the programme if you used too much detergent. If the symbol lights up and the display shows “Fod”, too much foam interrupted the wash process. Refer to the “Troubleshooting Guide” in your Instructions for Use. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * Reference programmes for Energy Label. [. . . ] As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have to open it urgently during a running programme, refer to “Reset a running programme before the end”. PROGRAMME START ; the Open the tap and press the “Start (Pause)” button blinking “Start (Pause)” button light becomes constant. The programme sequence indication shows the current programme phase, running from left to right through wash, rinse, spin, drain. In some phases, the remaining programme time is newly calculated If this is the case, the on the display will fade, and the remaining time is replaced by an animation. CHILD LOCK Activating the child lock prevents children from starting a wash cycle or changing the settings of a running programme. [. . . ]