User manual WHIRLPOOL HJA1703 INSTRUCTION FOR USE

[. . . ] DANGER Where there is a danger of damage to the appliance, utensils, surrounding areas and property. Please note them for your own safety. 3 Important safety information This manual contains important information regarding safety, the use and maintenance of your new hob. Read the manual carefully and keep it in an easily accessible place for future consultation. Before using the cooking hob Before use, remove: • Adhesives stuck on the hob. • Cardboard guards and protective plastic film. • Check whether the hob has been damaged during transport. [. . . ] • Cut an opening in the worktop of the given dimensions. • We recommend you seal the internal edges of the worktop with wood glue or silicone. • If not already in place, apply the supplied seal to the hob, after cleaning the adhesive surface thoroughly. 1) as shown, paying attention to the specified distances. • If the worktop is made of marble, plastic, ceramic, stone, etc. , the hob must be secured with special brackets (C) (fig. Place the 4 brackets (C) in position in accordance with the thickness of the worktop as shown in fig. Fasten the 4 screws (D) in the positions (E) (fig. 2). Glass-ceramic hob WARNING Remove any protective film before installing the hob. Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range. The hob should not be forced into the worktop. Forcing the glass-ceramic top may cause a crack (even later)!• If the worktop is made of wood, use the spring clips and screws provided. 5 Fig. 3 Electrical connection Electrical connections • Regulations require that the appliance be earthed. • Connection to the mains must be carried out by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations. • The installer is responsible for connecting appliances correctly to the mains and for observing the safety regulations. • The hob power cable must be long enough to connect the built-in appliance to the mains. • Observance of safety directives requires that a multi-pole switch with a minimum contact gap of 3 mm be used for the installation. • Do not use multiple plug adapters or extension leads. • After the hob has been installed, the electrical components must be inaccessible. WARNING Make sure that the voltage indicated on the rating plate is the same as the mains voltage. Technical data is given on the rating plate on the edge of the hob and also below: Electrical connection Supply voltage 230 V ~ Conductors (number and size) 3 x 2. 5 mm2 Connecting the hob to the power supply Note: the yellow/green earth wire must be connected to the screw with the symbol . 70 mm of the cable sheath from the power supply cable (G). [. . . ] • Food spills should be cleaned off before they bake onto the glass ceramic surface. Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed using a scraper for glass. Glass scrapers have a very sharp blade and must be handled with care. Troubleshooting guide The hob does not work • Make sure that the power supply is on. • Turn the hob off and on again, to make sure that the problem has been solved. [. . . ]