User manual WHIRLPOOL HJA1713 INSTALLATION

[. . . ] DANGER Where there is a danger of damage to the appliance, utensils, surrounding areas and property. Please note them for your own safety. 3 Important safety information Precautions and advice WARNING Accessible parts become very hot when the equipment is in operation. Keep children away from the appliance in order to avoid the risk of scalding and burns. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. • Do not leave the appliance unattended when frying food -risk of fire. [. . . ] - Secure using the 4 screws (B) provided that should be screwed into the pre-prepared holes. - Insert the hob into the pre-prepared hole ensuring that the clips (A) lodge into the bracket slots provided (C) (Fig. If the worktop is made of marble, ceramic, stone, plastic materials, etc. , order the installation kit, code 4812 310 19277 from an authorized after-sales service. A Fig. 5 6 Electrical connection Electrical connections Electrical connection must be made before connecting the appliance to the electricity supply. The appliance must be installed by a qualified electrician who is fully aware of current safety and installation regulations. Specifically, installation must be carried out in compliance with the regulations of the local electricity supply company. Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. Regulations require that the appliance be earthed: use conductors (including the earth conductor) of the appropriate size only. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above regulations. For the electrical connection use a H05 RR-F type cable as indicated in the table below: Power supply voltage Conductors 230V ~ + 230-240V ~ + 230V 3~ + 400V 3N ~ + 400V 2N ~ + Connecting to the terminal board Note: the yellow/green earth wire must be connected to the terminal with the symbol must be longer than the other wires. 70 mm of the cable sheath from the power supply cable (B). Then insert the power supply cable into the cable clamp and connect the wires to the terminal block as indicated in the connection diagram placed close to the terminal block itself. • Secure the power supply cable (B) by means of the cable clamp. • Close the terminal board with the cover (A) securing it with the screw provided. • After the electrical connection, fit the hob from the top and hook it to the support springs, according to the illustration. Amount x size 3 X 4 mm2 3 X 4 mm2 (Australia only) 4 X 1. 5 mm2 5 X 1. 5 mm2 4 X 1. 5 mm2 The appliance must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. WARNING The power supply cable must be long enough to allow the cooktop to be removed from the worktop and must be positioned so as to avoid damage or overheating caused by contact with the base. 7 Operating Operating the hob Hob description 2 3 Dimensions in mm Dimensions of the hob 4 1 1. Display Be careful: 5 Ø 180 Ø 210 Ø 145 Ø 145 42 mm To avoid permanently damaging the glass-ceramic top, do not use: • - Pots with bottoms that are not perfectly flat. • - Metal pots with enamelled bottom. Any aesthetic defects (scratches, surface marks, etc. ) must be reported immediately upon installation. 8 Control panel B F B B E A B C D Multiple zone: After selecting the desired zone and setting the level (as described in the previous section) press “F”: an indicator above the button turns on, activating the additional zone. The multiple zone can only be used if: 1) The cooking zone is provided with multiple zone; 2) The power level selected is greater than 0. To deactivate the multiple zone, press button “B” of the desired zone, then press “F” again. To set the Timer function, select the desired cooking zone and power setting then press the cooking zone key again and a luminous dot will appear on the display of the timercontrolled cooking zone. [. . . ] Any claim during the guarantee period MUST BE ACCOMPANIED BY THE RECEIPT related to the original purchase. The unit must be correctly installed and operated in accordance with the manufacturer’s instructions and used for normal domestic purposes. The guarantee does not cover accidental damage, missuse or alterations which are likely to affect the units. The guarantee is invalid if the unit is tampered with, or repaired by any unauthorised person. [. . . ]