User manual WHIRLPOOL HOB 440 S INSTRUCTION FOR USE

[. . . ] • Position the cooktop into the housing. • Put tabs (A) into plate; tooth (C) of the tabs should fit into the hole. • Tighten screw (B) until the cooktop is completely secured. [. . . ] • If possible, keep the pot covered when cooking. with little water in order to cut down cooking time. • A pressure cooker allows you to save even more energy and time. • Never cook the food directly on the glass ceramic cooktop, but in special pans or containers. NO PROTECTING THE ENVIRONMENT 1. Packing The packaging material can be100% recycled, as confirmed by the recycling symbol . Declaration of conformity These appliances are designed to come into contact with foodstuffs and they are constructed in compliance with Directive 89/109/EEC. • The appliances are designed solely for use as cooking appliances. for room heating) is considered as improper use and potentially dangerous. • The appliances are designed, built and sold in compliance with: • The safety requirements of “Low Voltage” Directive 73/23/EEC. • The protection requirements of EMC Directive 89/336/EEC. • The requirement of Directive 93/68/EEC. • Electrical insulation: Class (I). 2. Products The appliances are built from recyclable materials. If you decide to scrap the appliances act responsibly and observe local waste disposal by laws. Cut off the power cords so that the appliances cannot be connected to the mains. 12 6gb66001. fm5 Page 13 Tuesday, December 18, 2001 2:59 PM PRECAUTIONS AND GENERAL RECOMMENDATIONS • Before any maintenance on the appliance disconnect it from the electrical power supply. • Keep children away from the appliance when in use and when it has just been switched off. • The appliance must be repaired or adjusted exclusively by a qualified technician. • Make sure that the electrical wires of other electrical appliances near the cooktop do not come into contact with hot parts. • Do not switch on the cooking zones when there is no pan in position. [. . . ] • Has the control knob been turned to the correct power?• Set the main disconnect switch upline of the appliance to “OFF” for a few minutes and then back to “ON” and see if the problem persists. AFTER-SALES SERVICE Before contacting AFTER-SALES SERVICE 1. Try to solve the problem (see “TROUBLESHOOTING GUIDE”). [. . . ]