User manual WHIRLPOOL HOB 451/S INSTRUCTION FOR USE

[. . . ] 82569_GB. fm Page 75 Wednesday, March 21, 2001 5:18 PM 75 Cyan process 75, 0° 133, 0 LPI 82569_GB. fm Page 75 Wednesday, March 21, 2001 5:18 PM CONTENTS GB FEATURES BEFORE USING THE HOB HINTS FOR PROTECTING THE ENVIRONMENT WARNINGS FOR THE USE OF ELECTRICAL APPLIANCES GENERAL PRECAUTIONS AND SUGGESTIONS GAS HOB USING THE HOB CARE AND CLEANING TROUBLE-SHOOTING GUIDE AFTER-SALES SERVICE INSTALLATION INSTRUCTIONS PAGE 76 78 78 79 79 80 81 82 83 83 84 PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE 75 Black process 45, 0° 133, 0 LPI 82569_GB. fm Page 76 Wednesday, March 21, 2001 5:18 PM 2 GAS HOB - This appliance is Class 3 IT ES GB cat. Large burner - 3. 00 kW CONTROL PANEL 3. Rear burner control knob (2) Note: The electric ignition is incorporated in the knobs. 2 GAS HOB - This appliance is Class 3 FR BE cat. Large burner - 3. 00 kW CONTROL PANEL 3. [. . . ] • Time when you can be contacted. 83 Black process 45, 0° 133, 0 LPI 82569_GB. fm Page 84 Wednesday, March 21, 2001 5:18 PM • • • The installation, adjustment and modification of the appliance for the use of other gases (only for cat. II 2H3+ or II 2E+3+ models) must be performed by a trained installer. Failure to observe this rule will lead to cancellation of the guarantee. The appliance must be installed correctly and in conformity with the local regulations in force. Any operation must be performed with the appliance switched off. INSTALLATION ROOM • In the room where the hob is installed there must be enough air for correct gas combustion (2 m3/h x kW). The installer must refer to the national standards in force concerning ventilation and removal of combustion products. The natural flow of air must occur through one or more suitable openings which must be: - Permanent and made in the outside walls of the room to be ventilated, in an area away from sources of pollution. - So made that the opening outlets, both inside and outside the wall, cannot be blocked, even accidentally. so as not to reduce the useful section indicated above. - Situated at roughly floor level and such as not to cause disturbance to the correct operation of the combustion product removal devices. • When these openings cannot be made, the necessary air must come from an adjacent room, ventilated as required, as long as it is not a bedroom or a dangerous room. In this case the kitchen door must allow the passage of air. DISCHARGE OF THE COMBUSTION PRODUCTS The combustion products of gas appliances must be discharged through hoods connected directly to the outside. When this is not possible an electric fan can be used, attached to the outside wall or to the window, having a capacity such as to allow an hourly exchange of air of 3–5 times the volume of the kitchen. The fan can only be installed if there are suitable openings for the inlet of air. 84 Cyan process 75, 0° 133, 0 LPI 82569_GB. fm Page 84 Wednesday, March 21, 2001 5:18 PM INSTALLATION INSTRUCTIONS • The installation, adjustment and modification of the appliance for the use of other gases (only for cat. II 2H3+ or II 2E+3+ models) must be performed by a trained installer. Failure to observe this rule will lead to cancellation of the guarantee. The appliance must be installed correctly and in conformity with the local regulations in force. Any operation must be performed with the appliance switched off. • • INSTALLATION ROOM • In the room where the hob is installed there must be enough air for correct gas combustion (2 m3/h x kW). The installer must refer to the national standards in force concerning ventilation and removal of combustion products. The natural flow of air must occur through one or more suitable openings which must be: - Permanent and made in the outside walls of the room to be ventilated, in an area away from sources of pollution. - So made that the opening outlets, both inside and outside the wall, cannot be blocked, even accidentally. so as not to reduce the useful section indicated above. [. . . ] If the colours of the appliance power cord wires do not correspond to the coloured marking identifying the terminals in your plug, proceed as follows: - the yellow/green wire must be connected to the plug terminal marked with the letter E or the earth symbol, or coloured green or green/yellow; - the blue wire must be connected to the plug terminal marked with the letter N or coloured black; - the brown wire must be connected to the plug terminal marked with the letter L or coloured red. • • • • • The connection can be made directly to the mains by putting an all-pole switch with minimum opening between the contacts of 3 mm between the appliance and the mains. The supply cable must not touch hot parts and must be so positioned that it does not exceed the temperature of 75°C at any point. When the appliance is installed the switch or socket must always be accessible. The appliance must have its own supply; any other appliances installed near it must be supplied separately. N. B. [. . . ]