User manual WHIRLPOOL HOB 454/S INSTRUCTION FOR USE

[. . . ] Rear burner control knob (2) Note: The electric ignition is incorporated in the knobs. 76 Cyan process 75, 0° 133, 0 LPI 82569_GB. fm Page 76 Wednesday, March 21, 2001 5:18 PM FEATURES HOB 431 2 GAS HOB - This appliance is Class 3 IT ES GB cat. Large burner - 3. 00 kW CONTROL PANEL 3. Rear burner control knob (2) Note: The electric ignition is incorporated in the knobs. HOB 451 2 GAS HOB - This appliance is Class 3 FR BE cat. Large burner - 3. 00 kW CONTROL PANEL 3. [. . . ] The burner does not light: • Is the gas supply tap switched on?• Has the gas supply (methane) been cut off?• Have the cap or burner been repositioned correctly after cleaning?The burner does not stay lit: • Repeat the lighting operation turning the knob to the symbol representing the small flame. The electric ignition does not work: • Is there a power failure? AFTER-SALES SERVICE Before contacting the After-Sales Service: 1. Check whether you can deal with the problem yourself (See “Trouble-Shooting Guide”). Switch on the appliance again to check whether the problem has been solved. If it is still not working properly, call the AfterSales Service. When you call the After-Sales Service, please provide the following details: • A brief description of the fault. • The exact service number (the number can be read in ). • Your telephone number and local dialling code. - Situated at roughly floor level and such as not to cause disturbance to the correct operation of the combustion product removal devices. • When these openings cannot be made, the necessary air must come from an adjacent room, ventilated as required, as long as it is not a bedroom or a dangerous room. In this case the kitchen door must allow the passage of air. DISCHARGE OF THE COMBUSTION PRODUCTS The combustion products of gas appliances must be discharged through hoods connected directly to the outside. When this is not possible an electric fan can be used, attached to the outside wall or to the window, having a capacity such as to allow an hourly exchange of air of 3–5 times the volume of the kitchen. The fan can only be installed if there are suitable openings for the inlet of air. 84 Black process 45, 0° 133, 0 LPI 82569_GB. fm Page 85 Wednesday, March 21, 2001 5:18 PM Technical information for the installer The appliance must be installed by a qualified engineer following the manufacturer’s instructions and in compliance with local regulations in force. To fit the hob into the unit remember that: • Inside the unit there must be a space of at least 30 mm between the bottom of the hob and the top of an appliance or bracket. • Any wall to the side and above the hob must be at least 100 mm away. • The wall behind the hob must be at least 50 mm away. • When there is a wall unit or hood above the hob there must be at least 650 mm between the hob and the unit or hood. • The coatings of the walls of the unit or appliances near the hob must be heat resistant (“Y” protection against heating in compliance with standards EN 60335-2 6). Do not install the hob near inflammable materials (e. g. [. . . ] • The appliance must be connected to the mains by a trained electrician and according to the regulations in force. The appliance must be connected to the mains checking first of all that the voltage corresponds to the value given on the rating plate and that the section of the electrical cables can take the load indicated on the rating plate. The plug must be put into a socket connected to the earth system in compliance with safety rules. If the appliance is supplied without a plug fit a standard plug which is suitable for the power absorbed by the appliance. [. . . ]