User manual WHIRLPOOL HOB D30 S INSTRUCTION FOR USE

[. . . ] First make sure that the plug is correctly rated for the power consumption of the hob. • Plug the appliance in to an earthed socket. • Do not use multiple plug adapters or extension cables. • Connection to the mains must be through an omnipolar switch which has a contact gap of at least 3 mm. [. . . ] • When the appliance is installed, the switch or socket must always be accessible. • The supply cable must not come in contact with hot surfaces and must be positioned so that it does not at any time exceed the temperature of 50°C. • After the appliance has been installed, the electrical components must not be accessible. The producer does not accept responsibility for any damage or injury to persons or property resulting from non-observance of these requirements. Replacing the supply cable The supply cable may be replaced with a new one of the same type and connected to the junction box. Use cable type H05RR-F 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13 amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. • Do not leave the hob unattended when frying as this can increase the risk of fire. ENERGY SAVING TIPS • Use flat bottomed pots and pans whose base is the same size as or slightly larger than that of the hotplate. • If possible, keep pots covered when cooking. with little water in order to reduce the cooking time. • Using a pressure cooker saves further cooking time and reduces energy consumption. CARE AND CLEANING • Always disconnect the cooking hob from the mains before cleaning and maintenance. • Clean enamelled and/or stainless steel parts with a suitable cleaning product. • Do not use abrasive or corrosive materials. Do not use chlorine based cleaning products. • Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the work surfaces. • Clean the hot plates with a damp cloth and occasionally rub cooking oil well into them with a soft cloth. TROUBLESHOOTING GUIDE The cooking hob does not work. Check that: • The switch is in the ON position. [. . . ] • Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc. , on the work surfaces. • Clean the hot plates with a damp cloth and occasionally rub cooking oil well into them with a soft cloth. TROUBLESHOOTING GUIDE The cooking hob does not work. Check that: • The switch is in the ON position. • Check for a power failure. 12 6en66008. fm Page 13 Tuesday, March 18, 2003 9:44 AM AFTER SALES SERVICE Before contacting After Sales Service 1. Try to resolve the problem (see “Troubleshooting Guide”). [. . . ]