User manual WHIRLPOOL HOB V00 S N PROGRAM CHART

[. . . ] HOB V00 SN PRODUCT DESCRIPTION SHEET 1. Rear left round induction cooking zone Ø 210 mm Front left round induction cooking zone Ø 145 mm Rear right round inductioncooking zone Ø 180 mm Front right round induction cooking zone Ø 145 mm Display DE GB FR NL ES PT IT GR CH SE NO DK FI PL CZ SK HU RU Important: To avoid permanently damaging the glass ceramic hob, do not use: - pots with bottoms that are not perfectly flat. Any aesthetic defects (scratches, surface marks, etc. ) must be reported immediately upon installation. HOB DIMENSIONS (mm) TYPE: PLEII 230 V ~ /400 V 3 N ~ 50 Hz 7, 4 Kw TYPE: PLEII 230 V ~ 50 Hz 7, 4 Kw (only for UK) 5019 619 53611 HOW TO USE YOUR HOB F B C E D A B C On/Off Cooking zone selection and heat setting increase Heat setting decrease D E F Fast boil Child safety device Timer A To switch the hob on, hold down button A for about 2 seconds. [. . . ] This function remains on even after the hob has been switched off and on again. It can cancelled by holding down button “E” until the dot above the function button switches off. The TIMER function (if available) can be used both as a minute minder and as a timer for a selected cooking zone. To programme the timer for a given cooking zone, first select the desired cooking zone using one of the buttons “B”. To select the function, press the button with the clock symbol “F”. A dot lights up next to the timer display, indicating the cooking zone selected. Within 20 seconds, set the cooking time using buttons “F”“C” (1-99 min). After 20 seconds, the timer function begins automatically and the red indicator dot remains lit. At the end of the set cooking time, an acoustic signal sounds. If a cooking zone has been programmed to operate with the timer, it is switched off and the red indicator dot switches off too. The timer can be used to programme all cooking zones to work simultaneously. To use the function as a minute minder, press button “F” and then buttons “F”-“C” to set the desired time. When the set time has elapsed, an acoustic signal sounds. The FAST BOIL function switches the highest power setting on to bring water to the boil rapidly. [. . . ] Upon reaching the desired heat setting, the “A” disappears from the display, which shows only the selected heat setting (1-9). When the cooking zone is switched off, the residual heat indicator “H” remains on or flashes alternating with “0” until the temperature of the hob returns within safety levels. A H IMPORTANT: For safety reasons, the hob is equipped with an automatic cut-off function. Prolonged use of the same heat setting triggers automatic switch-off of the cooking zone (for example, after around 1 hour at maximum heat setting, the cooking zone switches off). [. . . ]