User manual WHIRLPOOL HOO D10 S INSTRUCTION FOR USE

[. . . ] Then mark and drill the hole, insert the wall plug and partially tighten 1 screw (Fig. • Fix the flue support as close as possible to the ceiling (Fig. For filter operation, in this phase, also fix the deflector (Fig. Hang the hood on the partially tightened screw (Fig. [. . . ] 4). 5019 618 33050/B GB 4 1 3 2 Fitting or replacing the carbon filter (filter hoods only). Change the carbon filter every six months. Fit the filters as shown in the figures below. Reverse the above procedure to remove the carbon filter. Light : move the switch to the right or press the button to switch on. Extraction speed : move the switch to the right or press the next button to increase extraction speed (or open the shutter ) . Lamp covers(or halogen lamps, depending on the model). Grease filters: a Metal grease filters have an unlimited life and should be washed once a month either by hand or in a dishwasher at a low temperature and in a short cycle. Washing in a b dishwasher can cause grease filters to turn white, but this in no way affects efficiency. Press the handle to release the filter Wash the filter and leave it to dry. Bulb/s: Detach the lighting unit and remove the burnt-out bulb. Halogen bulbs: Use a small screwdriver or any other suitable tool to prise off the bulb cover. Replace the bulb cover so that it clicks into position. Use only max 40 W - E14 bulbs or max 20 W halogen bulbs (depending on the model), taking care not to touch them with your hands. 1. 1. CLACK! 2. CLEANING THE HOOD Warning!Failure to remove oil and grease at least once a month could lead to fire. Use a soft cloth damped in a neutral detergent. Never use abrasives or alcohol. BEFORE USING THE HOOD Please read these instructions carefully in order to get the best out of your new hood. Packaging materials can be dangerous for children. Keep packaging materials (plastic bags, polystyrene, etc. ) well out of their reach. Make sure the hood has not been damaged during transport. [. . . ] Switch the appliance off and then on again to check if the problem has been eliminated. If the problem persists, contact the After-Sales Service. Specify: • the type of fault, • the product model given on the dataplate inside the hood, visible on removing the grease filters, • your full address, • your telephone number and area code, • the Service code (the number under the word SERVICE on the dataplate inside the hood, behind the grease filter). If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). [. . . ]