User manual WHIRLPOOL HOO E10 S PROGRAM CHART

[. . . ] Extractor Version: steam and fumes are exhausted to the outside. Proceed as follows: fit the collar with non-return valve supplied with the product (X) onto the exhaust opening of the hood, exerting light pressure. Screws are not required to attach the collar. Then fit the adaptor for the exhaust pipe (Y) onto the collar, exerting light pressure. [. . . ] 1: a - push the handles backwards b - and then downwards. After cleaning the grease filter refit in reverse order, making sure the entire extraction surface is covered. Fitting or replacing the carbon filter: Change the carbon filter every six months. Fit the filters over the motor: make sure the pins R on the manifold match the slots S, then turn clockwise until locked. Carry out in the reverse order to remove. Refit the grease filters. Cleaning the hood Fig. 2 Warning!Failure to remove oil/grease (at least once a month) could lead to fire. Use a soft cloth with a neutral detergent. Never use abrasive substances or alcohol. Before using the hood Replacing bulbs 1. Halogen lamps: Use a small screwdriver or other suitable tool to prise off the cover. Use only max 40 W E14 bulbs or max 20 W halogen bulbs (depending on the model), taking care not to touch them with your hands. Please read these instructions carefully and keep them for future reference, in order to ensure best use of your hood. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Make sure the hood has not been damaged during transport. Installation and electrical connections must be carried out by a qualified technician in compliance with the current local regulations. 5019 618 33061 GB 61833061GB. fm Page 3 Wednesday, March 29, 2006 4:39 PM SAFEGUARDING THE ENVIRONMENT 1. Packaging Packing materials are 100% recyclable and are marked with the recycling symbol . Comply with local regulations for their disposal. Packaging materials (plastic bags, polystyrene, etc. ) can be dangerous for children and should be kept well out of their reach. Product This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is scrapped suitably, you can help prevent potentially damaging consequences for the environment and health. The symbol on the appliance or accompanying documentation indicates that this product should not be disposed of as unsorted municipal waste but must be taken to a collection point for the treatment of WEEE. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further information on the treatment, recovery and recycling of this appliance, contact your competent local authority, the collection service for household waste or the shop where you purchased the appliance. Electrical connections Before connecting the hood to the power supply, make sure the voltage specified on the dataplate matches that in your home. The dataplate is located inside the hood behind the grease filter. [. . . ] • Is the fuse blown? AFTER-SALES SERVICE Before calling the After-sales Service 1. Check if you can fix the problem yourself (see ”Troubleshooting guide”). Switch the hood off and then on again to check if the problem has gone. If the problem persists, contact the After-sales Service. [. . . ]