User manual WHIRLPOOL HOO M00 OF INSTRUCTION FOR USE

[. . . ] The packing materials (plastic bags, polystyrene, etc. ) are a potential source of danger and must be kept out of the reach of children. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this appliance is correctly scrapped, the user can help prevent potentially harmful consequences for the environment and the health of people. The symbol on the product or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to a suitable collection centre for the recycling of electrical and electronic equipment. [. . . ] The product must be disposed of in compliance with local regulations on waste disposal. For further information on the treatment, recovery and recycling of this product, contact the competent local office, the household waste collection service or the shop where you purchased the appliance. Regular cleaning and maintenance is essential for correct hood operation and good performance. Frequently clean all encrustations from dirty surfaces to prevent the accumulation of grease. Do not “flambé” food under the hood. The room must have adequate ventilation when the hood is used at the same time as appliances operating on gas or other fuels. The discharge air must not be eliminated in a duct used to remove fumes produced by appliances operating on gas or other fuels, but must have a separate outlet. All the national regulations on air discharge envisaged by art. 7. 12. 1 of CEI EN 60335-2-31 must be observed. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. Do not leave pans unattended when frying, since the cooking oil could catch fire. Make sure the lamps are cold before touching them. The hood is not a shelf, therefore do not overload or place objects on it. Do not use or leave the hood without its lamps correctly installed - risk of electric shock. Wear work gloves for all installation and maintenance operations. The product is not suitable for outdoor use. The air sucked by the hood must not be eliminated through the same flue of the heating system or other appliances using gas or other fuels. 5019 618 33083/A D GB F NL E P I GR S N DK FIN PL CZ SK H RUS BG RO The mains voltage must match that given on the rating plate located inside the hood. If provided with a plug, connect the hood to a socket complying with the current regulations and located in an accessible area. If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. Electrical connection Cleaning the hood WARNING: Failure to remove oil/grease (at least once a month) could result in fire. [. . . ] Change the carbon filter every four months. Fit the filter/s over the motor according to the model: • align the pins R on the cowl with the slots S, then turn the filter clockwise until it locks in place. Reverse the above procedure to remove the carbon filter. Refit the grease filters. 4 3 3 1 2 Cleaning the hood 1. [. . . ]