User manual WHIRLPOOL HOO M10 S INSTRUCTION FOR USE

[. . . ] DATID HW400 GB ENGLISH 4 ENGLISH 4 Safety information Product description Control panel Cleaning and maintenance What to do if . . . Contents 4 7 7 7 9 Technical data Environmental concerns Electrical connection for Great Britain and Ireland only IKEA GUARANTEE 10 1 1 12 13 Before first use Your safety and that of others is paramount. Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. [. . . ] Keep this booklet for future consultation. ENGLISH 7 Product description 1 Chimney. 4 Grease filter. 1 2 3 Control panel A Light switch. Move the button to the right to increase power/speed. 4 0 1 0 1 2 3 A B Cleaning and maintenance WARNING: - Never use steam cleaning equipment. - Disconnect the appliance from the power supply. IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth. • Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. • Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions. IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals. To clean the grease filter The metal grease filter has an unlimited life and must be washed once a month by hand or dishwasher at low temperature and with a short cycle. With cleaning in a dishwasher ENGLISH 8 the grease filter may become dull; this does not effect its filtering capacity. Grease filter maintenance: 1. Disconnect the hood from the electric power supply. 2 Remove the grease filters: pull the spring release handle downwards, then remove the filter. 3. After cleaning the grease filter, remount in reverse order ensuring the entire extraction surface is covered. Lamp maintenance Disconnect the hood from the electricity. Warning Prior to touching the light bulbs ensure they are cooled down. Use a small screwdriver or other suitable tool to prise off the cover. Important: make sure you don’t touch the lamp with your hands. Charcoal filter maintenance (if the hood is installed in recirculation mode) 1. Remove the grease filters. 2. Fit the filter/s over the motor according to the model: - • align the pins on the cowl with the slots, then turn the filter clockwise until it locks in place. 3. Reverse the above procedure to remove the charcoal filter. [. . . ] • Damage to the following parts: ceramic glass, accessories, crockery and cutlery baskets, feed and drainage pipes, seals, lamps and lamp covers, screens, knobs, casings and parts of casings. Unless such damages can be proved to have been caused by production faults. • Cases where no fault could be found during a technician’s visit. • Repairs not carried out by our appointed service providers and/or an authorized service contractual partner or where nonoriginal parts have been used. [. . . ]