User manual WHIRLPOOL HOO M40 S INSTRUCTION FOR USE

[. . . ] If it does not have a plug (direct connection to the power supply) or if the plug is not in an accessible place, fit a suitable double-pole switch that ensures complete disconnection from the power supply in category III overvoltage conditions, complying with the installation rules. WARNING: Before reconnecting the hood circuit to the power supply and checking correct operation, always make sure the power cable is correctly fitted and that it was NOT crushed in its housing during installation. Make sure to have this operation carried out by a specialised technician. [. . . ] If any repairs are necessary, contact an authorised Service Centre (to ensure the use of original spare parts and correct repair). Failure to comply with these instructions can compromise the safety and quality of the product. AFTER-SALES SERVICE Declaration of conformity This product has been designed, manufactured and put on the market in conformity with: - safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces 73/23/EEC as amended) - protection requirements of “EMC” Directive 89/336/EEC amended by Directive 93/68/EEC. Troubleshooting guide If the hood does not work: • Is the plug properly inserted in the power socket?€¢ Is there a power failure?If the hood is not extracting enough: • Is the right speed selected?€¢ Do the filters need cleaning or replacing? • Are the air outlets blocked?If the lamp does not work: • Does the lamp need replacing? • Is the lamp correctly fitted?5019 618 33116/A D GB F I The hood is designed for use in “Extractor version” or in “Filter version” Extractor Version (see symbol in installation handbook) fumes are extracted and expelled to the outside through a fumes exhaust hose (not supplied) fixed to the collar at the top of the hood. In accordance with the exhaust hose purchased, provide a suitable fixing system to secure it to the collar. Warning: If already installed, remove the carbon filter/s. Filter Hood (see symbol in installation handbook) Air is filtered through a carbon filter/s and recycled into the surrounding environment. Warning: check that air recirculation is facilitated (to this end, carefully follow the instructions given in the installation handbook) Warning!If the hood does not have a carbon filter/s, order one/them and fit it/them before use. The hood comes provided with hardware (e. However, a qualified technician is needed to make sure that such hardware is suitable for your wall/ceiling. [. . . ] Fit the filter/s over the motor according to the model: • align the pins R on the cowl with the slots S, then turn the filter clockwise until it locks in place. Reverse the above procedure to remove the carbon filter. Extraction speed : move the button to the right to increase power/speed. [. . . ]