User manual WHIRLPOOL KBWG11NCSS PRODUCT FICHE

[. . . ] until the Start indicator lamp switches off. Select another programme and press the START button again. Wash cycle - Only open the dishwasher if necessary (Warning: beware of hot steam). - If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted. [. . . ] Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Carving forks, knives) must be arranged with the sharp end facing in towards the appliance. Depending on the model Half Load: Load the upper rack (see description of Options). Place the cutlery basket (D) in the upper rack. Rack height adjustment (also when loaded): • Lower adjustment: pull out the two rack handles outwards (E) and lower the rack. €¢ Upper adjustment: pull the two handles (E) upwards until the rack clicks into place (Factory setting). Removing the top rack to provide clearance for large items of crockery in the bottom rack: Open the rack guide retainers (F) on the right and left and remove the top rack. When the upper rack is in place the retainers must always be closed. Retainer closed Retainer open F F Lower rack: Depending on the model with fixed or tilting plate holders (G). half Load: Load the lower rack (see description of Options). Before contacting our After-Sales Service, take note of the following: • The nature of the fault • The appliance type and model • The service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side. Before using the dishwasher, read the user instructions!ADP 4737 Quick Reference Guide GB Options 3) Programme selector knob Time and failure display Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme starts and indicates the time remaining in hours and minutes. € Identification of faults for service technician On / Off button “Delayed start” button The wash cycle can be programmed to start after 1 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. The dishwasher will start at the set time. start button Switches “on” when the dishwasher is operating. Switches off at the end of the programme. €œHalf Load” button Possibility of only half loading the top and bottom racks. Select the required programme then press the “Half Load” button. [. . . ] Antibacterial rinse 4) 5) This function adds an antibacterial rinse at the end of the wash cycle, thereby guaranteeing a perfectly clean and sanitized load. The lamp will light up when the function is activated. If the temperature is not maintained during the antibacterial cycle (e. If the door is opened and remains open for a long time), the lamp will start blinking to indicate that sanitation is not guaranteed. [. . . ]