User manual WHIRLPOOL KCDC 1160 INSTRUCTION FOR USE

[. . . ] Instructions for use Important safety instructions Installation Advice on safeguarding the environment Troubleshooting guide After-Sales Service Cleaning Maintenance Material supplied Installation - Preliminary assembly instructions Installation dimensions Installation - assembly instructions Description and use of hood 4 5 6 6 7 7 8 9 10 11 12 13 Important safety instructions YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT. This manual and the appliance itself provides important safety messages, to be read and observed at all times. • The appliance is not intended for use by people (including children) with limited physical, sensory or mental abilities or without experience or knowledge of it, unless they are supervised or instructed in its use by someone responsible for their safety. • Do not repair or replace any part of the appliance unless specifically indicated in the manual. [. . . ] The light does not work • Check if the lamp needs replacing. • Make sure the lamp is correctly fitted. The remote control does not work • Check if the batteries need replacing. • Make sure the lithium batteries are correctly fitted. 6 After-Sales Service Before contacting the After-Sales Service: 1. See if you can eliminate the problem on your own by consulting the "Troubleshooting guide". Switch the hood off and then on again to check if the problem has been eliminated. If the following faults occur, contact the After-Sales Service immediately: • The hood makes strange noises and you are unable to detect any fault in it; • The motor runs unevenly, or strange noises can be heard, or it is faulty; • Switching does not work regularly. If the problem persists after carrying out the above checks, contact the nearest After-Sales Service. Always specify: • A brief description of the fault; • The type of appliance and exact model; • The Service number (the number after the word SERVICE on the dataplate inside the appliance). The Service number is also given in the warranty booklet; • Your full address; • Your telephone number. If any repairs are needed, contact an authorised Service Centre (to ensure that only original spare parts are used and that repairs are carried out correctly). Cleaning WARNING • Do not use steam cleaners. • Disconnect the appliance from the power supply. IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products comes into contact with the appliance, clean it immediately with a damp cloth. • Clean the surfaces with a damp cloth. If very dirty, add a few drops of washing up detergent to the water. IMPORTANT: Do not use abrasive sponges, or metallic scrapers or scouring pads. Their use could eventually spoil the enamelled surfaces. • Use specific detergents to clean the appliance and follow the manufacturer's instructions. • The remote control must only be cleaned with a damp cloth. IMPORTANT: Failure to observe the instructions for cleaning the hood and replacing the filters involves the risk of fire. Therefore make sure to follow the instructions. The manufacturer declines any liability for damage to the motor, fires caused by inadequate maintenance or failure to comply with the above instructions. 7 Maintenance WARNING • Use protective gloves. • Disconnect the appliance from the power supply. [. . . ] This function provides for a speed decrease from power level 3 to level 1, maintained for 15 minutes before the hood switches off. During timed operation, the corresponding LED blinks. • Button 5: Increases the extraction power to maximum, and then automatically returns to power level 3 after 5 minutes. The speed is displayed by lighting up of the LED of the corresponding speed. [. . . ]