User manual WHIRLPOOL KCDP 9050/I PROGRAM CHART

[. . . ] Do not leave a frying pan unattended when frying food as the cooking oil could catch fire. Constant cleaning and maintenance of your hood will ensure it works properly. Regularly remove all the ingrained food from dirty surfaces. Regularly remove and clean or change the filter. [. . . ] Before installation: • Check that the product purchased is the right size for the area where it is to be installed. • To make installation easier, temporarily remove the grease filters and other parts that can be removed. These should be refitted when installation is complete. See the relative paragraph for dismantling. • Remove the activated carbon filter/s if provided (again consult relative paragraph). This/these should be re-assembled only if you wish to use the hood in the recirculation mode. • Check that there are no parts (e. g. bags with screws, warranty) inside of the hood (for transport reasons). If there are, remove them and put to the side. • If possible, disconnect and remove the surrounding units and those near the installation area of the hood so that you have better accessibility to the ceiling / wall where the hood is to be installed. Otherwise, protect the units as much as possible and all the parts relating to the installation. Only Vented mode version: fit the deflector to the chimney support bracket using 4 screws. 7 • Hook the hood onto the lower bracket. • Fit the hood securely to the wall with screws and washers • Connect the venting pipe (vent pipe and straps for fitting are not provided and must be purchased separately) for the exhaust fumes to the connection ring found above the motor suction unit. The other end of the pipe should be attached to the extractor hood. If you wish to use the extraction hood in the recirculation mode, then connect the other end of the pipe to the connection ring on the deflector F. • Attach the chimneys and fit them above using 2 screws to the chimney support bracket, G. • Lower the lower part of the fully covered chimney suction unit slide down until it fits into the specific slot in the hood and attach it to the hood using 2 screws. chimney support bracket chimney support bracket centre line lower support bracket bottom fastener locations upper duct cover Recirculation mode only 9 Hood description Fig. Handle for unhooking the grease filter 4. Air outlet (only for use with vented mode version) 8. Perimetric suction panel Functioning Turn to maximum speed when there is a lot of steam in the kitchen. We would advise you to turn the suction on 5 minutes before starting to cook and leave it running after you have finished cooking for about another 15 minutes. [. . . ] When washing in the dishwasher, the metallic grease filter might discolour but its filtering abilities remain unchanged. In order to dismantle the grease filter, pull the spring handle to unhook it. Carbon filter (only in recirculation mode) Fig. 11 The carbon filter absorbs unpleasant smells produced when cooking. [. . . ]