User manual WHIRLPOOL KCPT 1210/I INSTRUCTION FOR USE

[. . . ] This is why you should make sure the room is well aired. Exhaust air from the hood should not be eliminated through the heating system chimney or appliances that run on gas or other fuels. The room should be sufficiently ventilated when the hood is used together with other appliances that run on gas or other fuels. Before touching the light bulbs, make sure they have cooled down. [. . . ] If the installation instructions for the gas cooking appliance specify a greater distance, then follow that instruction. Installation Before installation: • Check that the product purchased is the right size for the area where it is to be installed. • To make installation easier, temporarily remove the grease filters and other parts that can be removed whose dismantling and assembly are described here. These should be refitted when installation is complete. See the relative paragraph for dismantling. • Check that there are no parts (e. g. bags with screws, warranty) inside of the hood (for transport reasons). If there are, remove them and put to the side. • If possible, disconnect and remove the surrounding units and those near the installation area of the hood so that you have better accessibility to the ceiling / wall where the hood is to be installed. Otherwise, protect the units as much as possible and all the parts relating to the installation. Choose a flat surface and cover it with some protection where you can place the hood and parts. • Disconnect the hood by turning off the mains switch in the house when connecting the electrics. • Furthermore, check that near the area where you are installing the hood (in an area accessible even when the hood is fitted) there is an electric socket and that you can connect to an extractor towards the outside (only in the venting mode). • Carry out all the building work necessary (e. g. : installation of an electrical supply and/or hole to pass the venting pipe through). 6 5019_718_02000_GB 19-04-2007 15:06 Pagina 7 Installation Fig. 1 • Pull the handle F and remove the grease filters (1). Note: the number of grease filters can vary depending on the size of the hood. • Remove the screws that hold on the upper lids (the 900mm width model has 1 lid, models with a larger width come with 2 lids, right and left) (2). Note: the screws to be removed can be found in the positions indicated by the arrows in fig. 1. 1 and 1. 2 (only the 900mm width model). • Attach the connection ring B with 4 screws (4). Note: If necessary and/or foreseen for your installation, attach the reducer to the connection ring B. Without the reducer, pipes with a diameter of 200mm should be used; with the reducer you can use a venting pipe with a diameter of 150mm. 7 5019_718_02000_GB 19-04-2007 15:06 Pagina 8 Installation Fig. 2 • Attach the perforation layout to the wall (5). [. . . ] Once cleaned, refit the trays following the reverse procedure. Grease filter It should be cleaned by hand once a month (or when the system indicates that the filters are finished and need changing – if the model you own offers this option), with mild cleaning products, or in the dishwasher at a low temperature and on the short cycle. When washing in the dishwasher, the metallic grease filter might discolour but its filtering abilities remain unchanged. In order to dismantle the grease filter F, pull the spring handle to unhook it. [. . . ]