User manual WHIRLPOOL KCPT 9010/I PROGRAM CHART

[. . . ] Note: always use gloves when installing or carrying out maintenance work. Electrical connection The mains voltage should correspond with the voltage shown on the specifications label found inside the hood. If there is no plug, connect the hood to a socket that complies with current legislation and is in an easily accessible location. If there is no plug (direct connection to the mains supply) or the plug is not in an easily accessible location, fit a legally complying bi-polar switch that ensures the complete disconnection of the mains in the event of a category III line surge, in compliance with the installation regulations. IMPORTANT: before reconnecting the hood circuit to the power supply, check that it is working properly, that the mains cable has been properly fitted and that it has NOT been crushed in its holder during installation. [. . . ] The symbol on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste. Instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information on treatment, recovery and recycling of this product, contact your local authority, the household waste disposal service or the shop where you purchased the product. 5 5019_718_02000_GB 19-04-2007 15:06 Pagina 6 Instructions for installation and use This is an excessively heavy product and the movement and installation of the hood should be done by at least two or more people. Follow the instructions in this manual carefully. All responsibility is denied for problems, damage or fire to the appliance resulting in failure to comply with the instructions in this manual. Extraction Mode The hood is designed to be used in the suction version with external evacuation. Venting Mode The hood comes with an upper air outlet B for the discharge of fumes to the outside (Venting pipe and fixing straps not supplied). Installation The minimum distance between the upper pan support surfaces on the cooking appliance and the lowest part of the cooker hood should be no less than 50 cm in the case of electrical cookers and 70 cm in the case of gas or mixed cookers. If the installation instructions for the gas cooking appliance specify a greater distance, then follow that instruction. Installation Before installation: • Check that the product purchased is the right size for the area where it is to be installed. • To make installation easier, temporarily remove the grease filters and other parts that can be removed whose dismantling and assembly are described here. These should be refitted when installation is complete. • From inside and, from the outside of the hood, mark the holes for the final fitting (10). Note: see layout of the back of the hood with the final position of the holes/plugs/screws (Fig. • Make the holes and insert the plugs in the previously marked points (12). • Assemble the bracket for the chimney flue using the 4 screws supplied (13). Note: the extension of the chimney flue bracket must be identical to the internal width of the chimney flue. Attach the bracket to the wall with 2 plugs and 2 screws (14). • Hang the hood again on the brackets (15). Note: see assembly operations 10-12 for the number and position of the screws. 8 5019_718_02000_GB 19-04-2007 15:06 Pagina 9 Installation Fig. 3 • Attach a venting exhaust pipe (purchased seperately) to the connection ring (17). • Attach the upper chimney using 2 screws (19A) to the bracket (19B). • Lower the lower chimney section (20) and attach it to the upper side of the hood with 2 screws (21 – Fig. [. . . ] In order to dismantle the grease filter F, pull the spring handle to unhook it. 6 Disconnect the appliance from the mains supply. Before touching the light bulbs make sure they have cooled down. Remove the protective cover using a small flat screwdriver or a similar tool. [. . . ]