User manual WHIRLPOOL KDFX 6040 INSTRUCTION FOR USE

[. . . ] Connecting to water mains - Connections to the mains water supply must be carried out by a qualified technician in compliance with the manufacturer’s instructions and applicable local safety regulations. - The inlet hose must be securely clamped to the water tap to prevent leaks. [. . . ] - Before using the appliance for the first time, check water inlet and water drain for leaks. Voltage information is shown on the rating plate mounted inside the door on the right hand side. The appliance must be earthed as prescribed by law. do not use extension leads or multi sockets. If necessary, the power cable may be replaced with an identical one that can be requested from our After-Sales Service. The power cable must only be replaced by a qualified technician. For Austria: if the apparatus is series connected to a fault current switch, this must be sensitive to the pulsating current. Assembly instructions During assembly, unplug the appliance from the mains. Set any electrical screwdrivers to a low torque. Leave at least 3mm between the top edge of the wooden door and the worktop. Do not seal gaps between the appliance and adjacent units / worktop (for example with silicone). Attention: When transporting and assembling the appliance, always wear gloves to protect the fingers / hands from sharp edges and corners. If the appliance is installed at the end of a row of fitted units and touching a wall on one side, cover the hinge area (available from the After-Sales Service). Be careful with uneven installation surfaces: regulate the foot height, push the dishwasher carefully under the worktop. [. . . ] - All sizes in this maintenance and installation instruction are given in millimetres. - Packaging varies according to the type of dishwasher . [. . . ]