User manual WHIRLPOOL KDFX 7015 INSTRUCTION FOR USE

[. . . ] Instructions for use Precautions and general recommendations Parts of the dishwasher Technical information Baskets Control panel Dispenser Basic Course Programs Options Eco-dishwashing Fragile dishes Program Description Cleaning Rinse aid Salt Settings Fault indications Troubleshooting Performance information Installation instructions Installation and connection information Service & guarantee Quick Guide 4 5 6 6 8 8 9 10 10 11 12 12 13 15 16 17 18 19 21 22 23 30 30 Precautions and general recommendations 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol . Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. [. . . ] Then fill the compartment with max 1. 5 kg salt. Wipe away excess salt so that the cover can be properly screwed into place. Run a Normal wash program so that any salt in the machine is rinsed away. When the salt runs out, the salt symbol on the display* lights up. Unscrew the cover and fill the compartment with salt. Water is only needed on the first occasion!Run a Normal wash program so that any salt is rinsed away. Occasionally check to see if more salt is needed. A green indicator can be seen in the cover of the salt compartment. The indicator is not working If the indicator is not working, this may be because the float, which is positioned under the cover, has become stuck in salt residue. The float can be reached through the green arm located under the cover of the salt compartment. Move the float arm up and down to loosen it. Once the float has been loosened, press it down again. Models without a salt symbol in the display show green in the salt compartment cover when there is sufficient salt. Cover for the salt compartment *NB!After filling, there may be a short delay before the signal light goes out. Never pour dishwasher detergent into the salt compartment. It will destroy the water softener! 16 Settings Reprogramming Some of the machine's functions can be reprogrammed. You get into the machine's change program using the machine's ordinary buttons as per the instructions below. The selection will be retained until the next time you reset this function. Even if the machine is turned off at the main switch or loses power for any other reason, all selections registered before the interruption of power will be retained. Child-safe button lock You can prevent a child starting the machine by accident or changing the settings by programming the machine with a button lock, which requires the Temperature and Drying buttons to be pressed simultaneously to start up the machine. The button lock will automatically be reactivated after three minutes. 3. [. . . ] Cover the screw holes on the sides with the supplied plastic plugs. Push in the plugs diagonally to fit them in place. 7. Tighten the lock nuts on the front feet with 6mm open-ended wrench. 6. Check that the dishwasher's two front steel feet are solidly placed on the floor, that is, the dishwasher is not hanging in the air. [. . . ]