User manual WHIRLPOOL KFID60A PROGRAM CHART

[. . . ] Quick reference guide ON BUTTON PROGRAMME SELECTION BUTTON Press this button (repeatedly) until the indicator of the required programme lights up (see “Table of programmes” below). Chart BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE INSTALLATION INSTRUCTIONS!THE GUARANTEE IS NOT APPLICABLE IF FAULTS ARE CAUSED BY INCORRECT USE OF THE APPLIANCE. OFF BUTTON START BUTTON The indicator lights up during operation, flashes when a fault occurs and goes off at the end of the programme. START BUTTON RESET FUNCTION Press this button for at least 2 seconds; the selected programme and options are cancelled. Main failure displays (repeated flashing of the START indicator lamp) can be cancelled by RESETTING. [. . . ] If it has, the appliance will only start once the set time has elapsed. If necessary, set the delayed start to “0” (RESET the appliance). - Check that the water supply temperature is above 3°C. - The closure disk of the syphon hose connection must be removed. - The water inlet hose must not be kinked and the relative inlet filter in the water tap connector must not be clogged. - The water tap must be fully open during water inlet (minimum capacity: 0. 5 litres per minute). - In the event of frequent use of the Eco 50°C programme (if available), from time to time select the Frequent use of Eco 50°C. Intensive 70°C programme (if available). - The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see Clogged spray arms; filters dirty or not fitted correctly. Spray arms impeded by crockery or cutlery. - The spray arms must be able to turn freely and must not be impeded by crockery or cutlery. GB -6- What to do if. . . Crockery and cutlery. . . . . . salt indicator lit . . . have deposits: regeneration salt residue . . . are not dry . . . have discoloured plastic parts . . . opaque glasses, etc . . . removable deposits on glasses . . . glasses not sparkling . . . permanent deposits on glasses Rainbow effect. Dishes unsuitable for washing in dishwashers (porcelain), Usage of incorrect programmes for glasses. Not conform of glasses to washing in dishwashers (porcelain). - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Close the salt reservoir cap properly. - If you use a combined action detergent, try adding more rinse aid. - Synthetic materials do not dry well; if wet at end of cycle, wipe dry. Clean dishes left in dishwasher for a long time after end - In this situation, the presence of drops of water on dishes and on the sides of the dishwasher is normal. when using “delayed start” function). releasing the door 5 minutes before removing the dishes. Incorrect arrangement of the concave items in the rack. [. . . ] Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. We reserve the right to make technical modifications. - Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap; also after programme end in the event of any malfunction. - Repairs and technical modifications must be carried out exclusively by a qualified technician. [. . . ]