User manual WHIRLPOOL KGA 281 SPORT AL INSTRUCTION FOR USE

[. . . ] curtains and delicate clothing , dresses , skirts , shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] If you select “Rinse Hold” do not leave items to soak for too long. 30 800 800 700 800 800 800 800 800 700 700 Yes 1) — — — — — — — — — — — — — — 2) — — — — — Programme for treating delicate laundry with starch or softener. Programme for treating cotton or linen laundry with starch or softener. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:00 1:35 0:55 0:50 0:40 0:50 • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: the programme selector knob stops on . Appliance in “Rinse Hold”: • Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. €¢ If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again. PROGRAMME START Turn on the tap and press the “On/Off” button. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. Load the machine, close the drum doors and check that they are properly locked. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows: • Programme with pre and main wash • Main wash programme without prewash • Fabric softeners and conditioners • Chlorine bleach • Stain remover agents • Anti-scale agents (if necessary) 3. Turn the programme selector knob to the desired programme. Turn the temperature selector knob to the desired temperature. Turn the spin speed selector knob to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. [. . . ] If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. [. . . ]