User manual WHIRLPOOL KGE COMFORTFRESH328 IL PROGRAM CHART

[. . . ] To remove the net (for cleaning purpose, or to use it under another shelf), you have to first remove the glass shelf under which the net is currently placed. FAN WITH A BUTTON The fan improves temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. It is advisable to keep the fan active, so that the "6th Sense Fresh Control"/ "Green Intelligence ProFresh" function can work properly and also when the ambient air temperature is above 27 ÷ 28°C or if you perceive drops of water on the glass shelves or when there is extreme humidity. [. . . ] Temperature selection pushbutton is used to set desired temperature level, from warmest through lower to coldest . Pressing pushbutton setpoint will change cyclically. Temperature set-point is done for both compartments at one time – fridge and freezer. At first plug-in of appliance factory set-point is chosen – medium position. Following table shows set-points level: high temp. low temp. GB Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. DEFROSTING THE FREEZER COMPARTMENT The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness). The amount and rate at which frost accumulates depends on room conditions and how often the door is open. To defrost the unit, switch off the whole appliance and remove all food products. Leave the freezer door open to allow the frost to melt. Pull out the defrost water drain and place a container under the drain (see figure). When the operation is completed, put back the defrost water drain. Switch the freezer compartment, or the whole appliance, back on and store the food inside. REPLACING THE LIGHT (depending on the model) BULB's LIGHTING Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with a traditional bulb (with the same characteristics of the previous one) or a LED bulb of the same type available only at our After-sales Service Centers or authorized dealers. [. . . ] FREEZING FRESH FOOD Place the fresh food to be frozen on the upper basket in the freezer compartment. Avoid direct contact with already frozen food. To freeze the quantity of food shown on the rating plate, switch on Fast Cool function before placing fresh food to be frozen. [. . . ]