User manual WHIRLPOOL KGE335 PROFRESH A WS PROGRAM CHART

[. . . ] is the recommended Description: LED ON temperature settings. LED OFF To adjust the temperature in the freezer compartment, use the "Fridge / Freezer" button (1) to control the temperature in the freezer cabinet. The temperature in the freezer compartment may be set by the temperature setting pushbutton (3) on the control panel. On the left are described the 5 set points for high temp. [. . . ] To turn off the fan press the button (1a). If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 7) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. DEFROSTING THE REFRIGERATOR COMPARTMENT Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. The defrost water is automatically run into a drain hole and collected in a container, where it evaporates. DEFROSTING THE FREEZER COMPARTMENT The freezer should be defrosted once or twice a year or when excessive frost is present (3 mm thickness). The amount and rate at which frost accumulates depends on room conditions and how often the door is open. D GB F NL E P I GR S N DK FIN PRODUCT SHEET To defrost the unit, switch off the freezer compartment or the whole appliance, depending on the model, and remove all food products. Leave the freezer door open to allow the frost to melt. For appliances in figure only pull out the defrost water drain and place a container under the drain. When the operation is completed, put back the defrost water drain. Switch the freezer compartment, or the whole appliance, back on and store the food inside. REPLACING THE LIGHT BULB Always disconnect the refrigerator from the power supply before replacing any light bulb. If the inside light is not working, it is necessary to: 1. Remove the light cover: put the fingers into the side ventilation holes (1), stretch the cover gently and move it upwards. If necessary unscrew the broken bulb and replace it with the new one (use maximum 15W bulb). GUIDE TO SELECTING FUNCTIONS Functions and settings Fast Freezing: For more efficient freezing activate this function 24 hours before freezing fresh products. - Select Freezer compartment by using button (1), LED (2) shall turn ON. - Press and hold the temperature setting button Temp. °C until 3 green LEDs light up simultaneously (4) (5) (6). After 24 hours place the food to be frozen in the upper basket of the freezer compartment. This function is automatically disabled after 24 hours. [. . . ] "Dynamic Intelligence" function The "Dynamic Intelligence" function helps to maintain optimal conditions to storage of food and is automatically activated when: • a large amount of food is loaded into the refrigerator and freezer; • the freezer door is left open for a long time; • a prolonged power failure takes place, causing the internal temperature of the appliance to increase to values that cannot guarantee safe storage of food. ProFresh The ProFresh is activated by default and is working only with Fan on. To disactivate the ProFresh function press for at least 3 sec. both buttons Cavity selection "Fridge / Freezer" and "Temp. °C". [. . . ]