User manual WHIRLPOOL KGEE 3439 A LH PRODUCT FICHE

[. . . ] Door seals The crisper and the door seals are manufactured from materials that inhibit bacterial growth. Notes: - In case of power failure the cold accumulator helps to keep optimal storage temperature longer. - All shelves and door trays are removable. - The internal temperatures of the appliance depends on the ambient temperature, frequency of opening the doors, as well as location of the appliance. [. . . ] When the product is disconnected from the power supply and then reconnected, the control unit remembers previously set temperatures for freezer and refrigerator. FAN WITH A BUTTON The fan gives more even temperature distribution inside the refrigerator compartment, allowing better preservation of stored food. To switch on the fan press the button (1a). It is advisable to activate the fan when the ambient air temperature is over 27 ÷ 28°C or if you perceive drops of water on the glass shelves or in the severe humidity conditions. Note: Do not obstruct the air intake area with food items. The fan will run ONLY when the compressor is in operation. Remember to turn off the fan when there is a lower ambient air temperature. If the appliance has the fan it can be equipped with the antibacterial filter. Remove it from the box (found in the crisper drawer (item 6) and insert into the cover of fan (item 1b). The replacement procedure is attached with the filter. HOW TO START THE APPLIANCE After plugging the appliance to the mains, the appliance starts operation automatically. Particular control elements are activated: • The indicator lamps on the control panels light up for 2 seconds. • Activation of a beep for 1 second. Stop alarm / Stand-by Mode It allows the user to turn ON or to put in stand-by the product. This function is enabled even if any alarm or failure appears. • ON state: when the product is in the stand-by state to turn it ON, press & hold stand-by pushbutton for 3 s. • The product is turned ON; • All functions shall be enabled. • On/OFF stand-by state: when the product is ON and the stand-by pushbutton is held for 3 s, the appliance goes OFF. • The product is in stand-by mode loads are disabled. • All functions shall be disabled; • All indicators shall be turned OFF; • Refrigerator internal light shall be turned OFF. Notes: When two pushbuttons: stand-by and temperature setting are pressed at once and held to check indication of the alarms (displayed by lamps (4) (5) (6)) stand-by function is locked. Door open alarm- when the refrigerator compartment door remains open for more than 4 minutes: • Light in the refrigerator compartment turns OFF • Green lamps flash (4) (5) (6) . When the door is closed the product returns to normal operation. • The beep will stop • The green lamps (4) (5) (6) stop flashing • Light in the refrigerator compartment turns ON when the fridge door is opened again. [. . . ] It only indicates the necessity to assess the quality of food in the freezer and refrigerator compartments. To deactivate the alarm, press and hold Temperature selection pushbutton & stand-by button and keep pressed until the flashing of the green lamps (4) (5) (6) go off. - The temperature will return to the normal operating cycle level and the beep will stop. "Dynamic Intelligence" function The "Dynamic inteligence" function helps to maintain optimal conditions to storage of food and is automatically activated when: • a large amount of food is loaded into the refrigerator and/or freezer; • the refrigerator and/or freezer door is left open for a long time; • a prolonged power failure takes place, causing the internal temperature of the appliance to increase to values that cannot guarantee safe storage of food. OTHER ABNORMAL APPLIANCE OPERATIONS DISPLAYED BY LAMPS In case of abnormal appliance operation, all the temperature selection lamps will flash and a beep will sound. [. . . ]