User manual WHIRLPOOL KGI 3112/A/1 PROGRAM CHART

[. . . ] Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer's instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. Packing The packing material is 100% recyclable and bears the recycling symbol . [. . . ] • For the water connection, use the pipe supplied with the new appliance; do not reuse that of the previous appliance. • Power cable modification or replacement must only be carried out by qualified personnel or by After-sales Service. • It must be possible to disconnect the appliance from the power supply by unplugging it or by means of a mains two-pole switch installed upstream of the socket. 13 CLEANING, SANITIZATION AND MAINTENANCE OF THE ICE AND/OR WATER DISPENSER (if present) Failure to follow the instructions regarding sanitizing can compromise the hygienic safety of the water dispensed. • When using the appliance for the first time, discard the first 9-14 litres of water, equivalent to 6-7 minutes of dispensing (not necessarily consecutive, but before initial consumption) and discard the ice produced in the first 24 hours. • Reposition the removable water dispenser (if present), ensuring your hands are hygienically clean. • Periodically clean the ice bucket or drawer under running water only. • Every six months, sanitise the water and ice dispensing system with disinfectant solutions (sodium hypochlorite based) suitable for materials in contact with food and which do not alter the characteristics of the materials. • Replacement of any parts of the ice and water dispenser must be carried out using original spare parts provided by the Manufacturer. • Any work on the appliance must be carried out by a qualified technician or the After-sales Service. FIRST USE Connect the appliance to the mains power supply. The ideal temperatures for preserving food have already been set at the factory (3-5/MED). Note: After switching the appliance on, it will be necessary to wait for 2 to 3 hours before a temperature suitable for a standard appliance load is reached. MAINTENANCE AND CLEANING Before any cleaning or maintenance operation, unplug the appliance from the mains or disconnect the electrical power supply. The bottles can also be turned upside down, on their tops. The design of the bottle holder prevents it from being fully removed. Lift it up at the back and pull it towards you. Warning!If the inner door is fitted with accessories (door trays, containers. . . ), fit the bottle holder so that it does not prevent proper door closure. The bottle holder can accommodate a maximum of 9 x 0. 75 litre bottles (max. total weight 13 kg) - see the label below the thermostat box inside the appliance. Defrost water drain outlet (2) Underneath the refrigerant plate which cools the entire refrigerator compartment (fitted on the rear wall) is the drain channel and hole for defrost water. The drain channel and hole must not be blocked (for example, with food residue). Check and clean them regularly (for example, with a straw). Crisper drawer The crisper drawer is positioned at the bottom of the refrigerator, below the glass shelf. Humidity is higher in this zone, keeping fruit and vegetables fresher for longer. [. . . ] Leave the door ajar to allow frost to melt. 2, pull out the defrost water drain pipe and place a basin underneath. After defrosting, fit the drain pipe back in place. Switch the freezer compartment, or the whole appliance, back on and reposition the food Fig. [. . . ]