User manual WHIRLPOOL KGIE 3205/A INSTRUCTION FOR USE

[. . . ] Contact the after-sales service to replace LEDs. 9 WHEN THE APPLIANCE IS NOT USED Unplug the appliance from the mains, empty, defrost and clean it. Leave the doors open just enough to allow air to circulate inside both compartments. [. . . ] To freeze fresh food, place it on the top or highest shelf, leaving enough space around packages to allow air to circulate. Refreezing partially thawed food is not recommended. Do not place food to be frozen beside food that is already frozen. When freezing large quantities of food, a temperature alarm may occur. Removing drawers (depending on model) Pull the drawers all the way out, lift them up a little and remove. Note: to obtain more space, the freezer compartment can also be used without the upper drawers. We recommend leaving the lower drawer in. Check that once all foodstuffs have been replaced on racks/shelves the door closes properly. Making ice cubes Fill the ice cube tray (where provided) 2/3 full and place it in the freezer compartment. Never use sharp or pointed objects to remove it. Note: Ambient air temperature, the frequency of door opening and the position of the appliance can all affect temperatures inside the refrigerator and freezer compartments. We therefore recommend you set the temperature on the basis of these factors. HOW TO DEFROST THE FREEZER COMPARTMENT We recommend defrosting the freezer once or twice a year or when excessive frost has formed (3mm thick). The amount of ice which forms and the rate at which it builds up depends on room temperature and humidity, and on how often the door is opened. To defrost, unplug the appliance and remove all foodstuffs. [. . . ] 1 IMPORTANT If the control panel does not show the symbol (see Quick Reference Guide), to guarantee correct appliance operation, adequate food storage conditions and to optimize energy consumption, do not remove the Meat and Fish box. Fig. 2 12 AFTER-SALES SERVICE Before contacting the After-Sales Service: Switch the appliance on again to see if the problem has been solved. [. . . ]