User manual WHIRLPOOL KGIF 3305/A PRODUCT FICHE

[. . . ] When "FF" is shown on the display, the "Fast Freezing" function is enabled. button. Q R Vacation This function can be used during extended absences. Press and hold the "Fridge C°" button for 3 seconds to enable/disable the function. The display will show the refrigerator compartment temperature (+12°C). [. . . ] The freezer remains enabled. Switching off acoustic alarms To switch off acoustic alarms, press the "Reset Alarm" button. 10/10 - Bauknecht, Polar and Ignis are registered trademarks of the Whirlpool group of companies. - © Copyright Whirlpool Europe s. r. l. All rights reserved - http://www. bauknecht. eu Printed in Italy On / Stand-by Press and hold for three seconds to enable/disable the appliance. Notes: This operation will not disconnect the appliance from the power supply. Green Intelligence (if installed) This activates automatically to signal that the appliance is working to quickly reach optimal storage conditions. Temperature or Malfunction Alarm See table below. Key Lock The key lock can be enabled/disabled by pressing and holding the "Reset Alarm" key for three seconds until a beep sounds to confirm your selection: "LO" appears on the display for a few seconds. A beep will sound and "LO" will appear on the display for a few seconds if a key is pressed while the key lock is enabled. Refrigerator Compartment A. Bulb or LED light (depending on the model) B. Lid for Special Box ("Meat &Fish" or "Zero Degrees") (if included) E. Special Box ("Meat & Fish" or "Zero Degrees") (if included) F. Rating plate (at the side of crisper drawer) I. If the control panel has 2 displays, check for a refrigerator door open alarm (see previous line). In all other cases, you may need to replace the light. It is not cold enough inside the compartments. There could be various causes (see "Solutions" column). Water collects at the bottom of the refrigerator compartment. The front edge of the appliance near where the door seal strikes is warm. It is a design feature to prevent condensation from forming. The control panel won't do anything: Every time a key is pressed, The "Key Lock" "CL" or "LO" appear on one or both displays. function has been enabled. Disable the function as explained in the Quick Start Guide. The red indicator lamp will light up (if not previously disabled). Temperature Alarm Freezer Compartment and a beep will sound The temperature alarm indicates that the temperature in the compartment is not ideal. This can happen: When it is first used after defrosting and/or cleaning, when freezing large quantities of food or when the freezer door doesn't close properly. Malfunction Alarm The alarm indicates that a technical component has malfunctioned. Blackout Alarm (where provided) This alarm activates when there has been an extended power failure causing the freezer compartment temperature to rise. The value flashing on the freezer display is the highest temperature reached during the power failure. Antibacterial and anti-odour filter exhausted (if installed). [. . . ] Replace the antibacterial filter. Press the mute acoustic alarm button to switch off the sound signal. The red indicator lamp goes off automatically when an optimal temperature has been reached. If the temperature alarm persists, contact an authorized After-Sales Service. The red indicator lamp is flashing, there are letters on the single display, and a buzzer is sounding (if not previously disabled). [. . . ]