User manual WHIRLPOOL KGIN 1183 A INSTRUCTION FOR USE

[. . . ] IMPORTANT: To operate properly, the function must be active during both night and day. The function remains active until deactivated (or it deactivates in the event of a blackout or appliance switch-off). To deactivate the function, press the button again. [. . . ] Note: the appliance's declared energy consumption refers to operation with the Eco night function deactivated. GB Fan (where provided) The fan is factory set to ACTIVE. The fan can be deactivated by pressing the button on the base (as shown in the figure). If the room temperature exceeds 27°C or if water droplets form on the glass shelves, the fan must be on in order to guarantee the correct preservation of food. Deactivation of the fan enables energy consumption to be optimised. Fast Cool Press the "Temperature" button for 3 seconds to cool the refrigerator compartment quickly, or 6 hours before placing large quantities of fresh food in the freezer compartment. When the function is active, the sequence shown in the figure will appear on the display. This function is automatically deactivated after 30 hours, or manually by pressing the "Temperature" button again. Note: Do not place fresh food to be frozen in direct contact with already frozen food. Stop Alarm To deactivate acoustic signals, press the "Stop Alarm" button. Key Lock The key lock can be activated/deactivated by pressing and holding the "Key Lock" button for 3 seconds, until you hear a confirmation tone (the icon lights up). allows the appliance to be powered) - the household electrical system protection devices are efficient - the power cable is not broken. Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a new one (see the section "Lamp or LED replacement"). Models with LED lights: contact the authorised Service Centre. Activate the appliance with the On/Standby button. Make sure: - the doors close properly - the appliance is not installed near a heat source - the set temperature is adequate - the circulation of air through the vents at the bottom of the appliance is not obstructed. Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning"). To deactivate the acoustic alarm temporarily, press the alarm deactivation button; to eliminate it completely, close the refrigerator door again. Press the "Stop Alarm" button to deactivate the acoustic signal. The control panel is switched off, the appliance does not work. The light may need replacing. The appliance could be in On/Standby mode. The temperature inside the compartments is not low enough. There could be various causes (see "Cures"). There is water on the bottom of the refrigerator compartment. [. . . ] The front edge of the appliance, at the door striker seal, is hot. The red light The red light flashes and an acoustic alarm sounds. comes on and the refrigerator compartment temperature indicators The defrost water drain is blocked. [. . . ]