User manual WHIRLPOOL KGIN 3182/A PRODUCT FICHE

[. . . ] ) out of children's reach, as they are potentially dangerous. Water and electrical connections • All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions (refer to the enclosed assembly instructions) and current local safety regulations. The appliance must only be used in the household for the prescribed uses. • PROTECTING THE ENVIRONMENT 1. [. . . ] €¢ Fix the drain hose to the siphon with a clamp to prevent it from coming off during operation. €¢ For appliances with water-stop system only: If the water connections are made correctly according to the instructions, the water-stop system safeguards your home against damage caused by flooding. Electrical connection: • Observe the current regulations issued by your local electricity supplier. €¢ Voltage information is shown on the rating plate mounted inside the door on the right hand side. €¢ Before carrying out maintenance, disconnect the mains plug. €¢ The power cable must only be replaced by a qualified technician. €¢ The manufacturer cannot be held responsible for damage caused by incorrect earthing of the appliance. 61 ELECTRICAL CONNECTION For Great Britain Only The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN- “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured red. €¢ If all of the test squares become red, set the hardness selector to 3. How to fill the salt container: Warning: only use dishwasher salt!Do not fill the salt container with unsuitable substances, such as detergent, as this will cause irreparable damage to the water softener system. Unscrew the cap by turning it counter-clockwise. When first using the dishwasher: fill the salt container with approximately 1 litre of water. Fill the salt container to the rim with salt (using the funnel provided) (when filling for the first time use min. Screw the cap back on by turning it clockwise. After filling the regeneration salt container, immediately start a wash programme (the Prewash programme alone is not sufficient), so as to eliminate any residual saline solution straight away and avoid corrosion. Salt level indicator: The dishwasher is equipped with an electric or visual salt level indicator (depending on the model installed). Electric indicator: The salt level indicator lamp on the control panel lights up when the salt container is empty. Visual indicator: The green float is clearly visible in the cap window when the salt container is sufficiently full. [. . . ] Additional electric indicator (if provided): The indicator lamp on the control panel lights up when more rinse aid needs to be added. /LJKW DGGULQVHDLG 64 HOW TO FILL THE DETERGENT DISPENSER A small compartment (A) and a large one (B) are provided for the detergent. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies for different brands. [. . . ]