User manual WHIRLPOOL KHGH 7510/I INSTRUCTION FOR USE

[. . . ] - Use pans with a similar diameter to the burner (see the table on this page) - Use flat bottomed pans except with the wok support. - Do not use excessive water when cooking foods and use the lid. - Ensure that pans are fully supported by the pan supports and do not protude over the edges. You should do not use: - Cast iron pots and pans, statite stone grills or terracotta dishes on the hob as this may damage the pan supports. [. . . ] • This hob is designed to operate perfectly with any oven in the KitchenAid range. The Manufacturer declines all responsibility should any other make of oven be installed. The manufacturer declines all responsibility should another make of oven be installed. Before installation, please ensure that: • Warning: this is a heavy products which requires the installation to be carried out by two people. • The gas supply (type and pressure) and the calibration on the hob are compatable ( see serial number plate on the hob and the table on page 6). • The cabinetry and appliances surrounding/next to the hob rea heat resistant and in compliance with local regulations. • The products of combustion are removed from the atmoshere in the room by using an extraction hood or electrical fan installed to the walls and or windows, in line with current regulations. • The air circulates naturally through a suitable opening that is no less than 100cm2 in cross section, which must be: - perminent and accessable on the walls of the room being ventilated and extracting towards the outside. - created in such a way that the openings both inside and out cannot be obstructed, even in error. - Protected by plastic grill, metallic netting etc that should not reduce the 100cm2 cross section - Located in such a position so as not to interfere with the extraction of the products of combustion. Gas connection Connection to the mains gas system must be carried out by a competant, registered person, in compliance with current legislation. • The connection of the hob to the gas mains network or gas cylinder must be done using a rigid copper or steel pipe with parts that comply with local standards, or using a flexible stainless steel pipe with continuous surfaces that comply with local standards. The flexible metallic pipe should be no longer than 2 linear metres. • Before connecting the pipe with the rubber part (A), ensure that seal (B) is in place (this part, provided complies with EN549). Warning: if you use a stainless steel flexible pipe, it must be installed in such a way that it does not come into contact with mobile parts like drawers or kitchen cupboards and passes at a point free of obstacles where it can be examined in its entirety. • After connecting to the gas mains, use soap and water to check there are no leaks. 9 Electrical connection The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch. • If damaged, the power cable must be replaced with an identical type of powercable ( H05V2V2-FT90 ºC, or H05RR-F type). We recommend that this operation be conducted by our After Sales Service. Please contact our Customer Care Centre on 00800-3810-4026. • The manufacturer declines all responsibility for damage to persons, pets or goods as a result of failure to comply with the regulations above. L Earth (yellow/green) N Installation 1. After cleaning the surfaces around the edges, fit the seal provided. [. . . ] the bottom of the pot is perfectly flat. the pan supports are correctly positioned with all the rubber feet in place. If, despite all these checks and after tuning the hon off and on again, you are still experiancing problems please contact our Customer Care Centre on 00800-3810-4026. After Sales Service Before contacting our Customer Care Centre please check to see if the problem can be fixed by refering to the troubleshooting guide. If the fault persists contact us on 00800-3810-4026. [. . . ]