User manual WHIRLPOOL KHGH 9010/I/01 INSTRUCTION FOR USE

[. . . ] - Convectors such as metal netting, or others. - The use of two burners simultaneously with just one container such as a fish kettle. Important: Do not rest or drag the pan supports upside down on the hob as this could scratch it. Failure to comply with these recommendations could lead to the glass ceramic hob being damaged, or broken and the safety of your appliance being compromised. [. . . ] • Do not obstruct the air vents at the back of the appliance in any way. 7 Safeguarding the environment Packing The packing material is 100% recyclable and is labelled with the recycling symbol . Please dispose of all packing responsibly and carefully. Product This appliance is marked according to the European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE). By ensuring that this product is disposed of correctly, you will help prevent potentially negative consequences for the environment and human health. The symbol on the product, or on the documents accompanying this appliance indicates that this product should not be disposed of as household waste. Please dispose of this appliance at an Electrical & Electronic Equipment Collection point as in accordance with local environmental regulations for waste disposal. For details of your local Collection Point please contact your Local Authority. EC Declaration of conformity This appliance has been designed, constructed and marketed in compliance with: - safety requirements of "GAS" Directive 2009/142/EC (ex-90/396/EEC); - safety objectives of "Low Voltage" Directive 2006/95/EC (which replaces 73/23/EEC and subsequent amendments); - protection requirements of "EMC" Directive 2004/108/EC. This appliance is suitable for contact with foodstuffs and complies with EC Regulation no. 1935/2004. 8 Installation Technical information for the installer • This appliance can be built into a 20mm to 40mm thick worktop. • If no oven is to be installed below the hob, a panel must be fitted under the hob to avoid hob damage and protect the cupboard contents. This panel must cover the whole of the underside of the hob and must be positioned so that an air gap of at least 20mm between the panel and hob underside is maintained, as a minimum, and as a maximum 150mm to the underneath of the work surface. Position the hob inside the cut-out obeying all the hood and cabinetry clearances on page 6. Use the fixing pieces (A) provided, to secure the hob to the worksurface, with screws. Note: the electrical power cable must be long enough to allow the hob to be lifted out from above. A 10 Adaption to a different type of gas supply If you are using a different kind of gas from the one indicated on the serial no. plate and the orange label on the back of the hob, you must replace the injectors; in the case of the Wok burner, adjust the primary air (see Injector table on page 6). The orange label should be removed and kept together with the manual. Use pressure regulators suitable for the gas pressures indicated on page 6 • In order to replace the injectors, contact the Customer Care Centre on 00800-3810-4026, or a qualified electrician. • Injectors not supplied as standard should be requested from the Customer Care Centre on 00800-3810-4026. • Regulate the minimum levels of the taps. Note: with liquid petroleum gas ( G30/G31) the bypass screw must be screwed in fully. If you then experiance difficulty in turning the control knob, contact our After sales Service though our Customer Care Centre on 00800-3810-4026, who will arrange for a replacement after ascertaining that the tap is damaged. Replacing the injectors Note: Refer to the table on page 6 to ensure the correct type of injector is to be fitted. Unscrew the injector (C) with a box spanner 7. [. . . ] all the parts on the burner are properly positioned. the button was pushed in properly when turning on the burner for the time required to activate the safety thermocouple. the burner’s openings are not blocked in relation to the thermocouple. the end part of the thermocouple is clean. [. . . ]