User manual WHIRLPOOL KHMF 9010/I/01 INSTRUCTION FOR USE

[. . . ] Minimum internal crown flame. A B Gas burner functions This hob is fitted with three professional gas double crown wok burners, which means that the gas burners are extremely flexible. Flexible enough to allow cooking at extremely high temperatures whilst also allowing cooking over a very low heat thanks to the central crown. Even when the induction part is not on, the gas burners will work anyway. Turning the gas burners on - Push in the corresponding control knob to turn on one of the burners and rotate it anticlockwise until the indicator on the control knob is lined up with the maximum flame symbol . [. . . ] Make sure children do not play with the appliance. • Before doing any maintenance work on the appliance, disconnect it from the electrical power supply. • Keep children away from the appliance when it is in use and when it has just been switched off. • The appliances should only be repaired or adjusted by a qualified electrician. • Make sure the electrical wires of other electrical appliances do not come into contact with hot parts. • The induction zones will not switch on if the pan is not either the right size, or do not attract a magnet. If the magnet sticks to the bottom of the pan then it is magnetic and can be used If the pan is taken off the cooking area, the zone will switch off and a “U” is shown in the display. This will disappear when the pan is replaced back on the cooking zone. • Avoid the use of high pressure water or steam cleaning equipment. • If liquids spill or boil over, the hob may switch off. In order for it to be switched back on again, carefully dry the control panel area. that, under no condition, should reduce the practicable section indicated above • Located close to the floor and placed in such a way that it does not interfere with the extraction of the combustion smoke. 11 5019_719_01120_GB_STEP_FILO:Layout 1 19-07-2007 14:04 Pagina 12 Gas connection The gas mains system must comply with local regulations. • The paragraph on “national legislation reference” shows the local legislation specific to the country of destination. • Should there be no information regarding your country of interest, ask for further details from the installer. • The connection of the hob to the gas mains network or gas cylinder must be done using a rigid copper or steel pipe with parts that comply with local standards, or using a flexible stainless steel pipe with continuous surfaces that comply with local standards. The flexible metallic pipe should be no longer than 2 linear metres. • Before connecting the pipe with the rubber part (A), insert the seal (B) provided, that complies with EN 549. Warning: if you use a stainless steel flexible pipe, it must be installed in such a way that it does not come into contact with moving cabinetry like drawers or kitchen cupboards and passes at a point free of obstacles where it can be examined in its entirety. • After connecting to the gas mains, use soap and water to check there are no leaks. Electrical connection The electrical connections must comply with local standards. • Information on the voltage and power absorbed are shown on the serial no. • The appliance must be earthed by law. • When installing the appliance you must make sure there is a multipolar switch with contact opening equal or greater than 3mm. [. . . ] Before calling the Customer Care Centre, see if the problem you are encountering is mentioned in this guide. Contact the Customer Care Centre to replace the power cable. The burner doesn’t come on or the flame is uneven. Check that: • the gas or electricity supply is not interrupted and, in particular, that the main gas tap at source on the hob, is open; • the gas cylinder has not run out; • the gas outlet openings to the burner have not been obstructed; • the end part of the ignitor isn’t dirty; • all the parts on the burner are properly positioned;there is not a draft near the hob. [. . . ]