User manual WHIRLPOOL KHMS 9010/I/01 INSTRUCTION FOR USE

[. . . ] Minimum internal crown flame. A B Gas burner functions This hob is fitted with three professional gas double crown wok burners, which means that the gas burners are extremely flexible. Flexible enough to allow cooking at extremely high temperatures whilst also allowing cooking over a very low heat thanks to the central crown. Even when the induction part is not on, the gas burners will work anyway. Turning the gas burners on - Push in the corresponding control knob to turn on one of the burners and rotate it anticlockwise until the indicator on the control knob is lined up with the maximum flame symbol . [. . . ] • Before doing any maintenance work on the appliance, disconnect it from the electrical power supply. • Keep children away from the appliance when it is in use and when it has just been switched off. • The appliances should only be repaired or adjusted by a qualified electrician. • Make sure the electrical wires of other electrical appliances do not come into contact with hot parts. • The induction zones will not switch on if the pan is not either the right size, or do not attract a magnet. If the magnet sticks to the bottom of the pan then it is magnetic and can be used If the pan is taken off the cooking area, the zone will switch off and a “U” is shown in the display. This will disappear when the pan is replaced back on the cooking zone. • Avoid the use of high pressure water or steam cleaning equipment. • If liquids spill or boil over, the hob may switch off. In order for it to be switched back on again, carefully dry the control panel area. • Metal objects such as knives, forks, spoons or pan lids should not be placed on the cooking surface as they could activate the induction zone and become hot. • Should there be no information regarding your country of interest, ask for further details from the installer. • The connection of the hob to the gas mains network or gas cylinder must be done using a rigid copper or steel pipe with parts that comply with local standards, or using a flexible stainless steel pipe with continuous surfaces that comply with local standards. The flexible metallic pipe should be no longer than 2 linear metres. • Before connecting the pipe with the rubber part (A), insert the seal (B) provided, that complies with EN 549. Warning: if you use a stainless steel flexible pipe, it must be installed in such a way that it does not come into contact with moving cabinetry like drawers or kitchen cupboards and passes at a point free of obstacles where it can be examined in its entirety. • After connecting to the gas mains, use soap and water to check there are no leaks. FOR BELGIUM ONLY: It is necessary to replace the elbow connection (A) on the appliance, with the one supplied. Important: if a stainless steel hose is used, it must be installed so as not to touch any mobile part of the furniture. It must pass through an area where there are no obstructions and where it is possible to inspect it on all its length. After connection to the gas supply, check for leaks with soapy water. Attention: Should you experience difficulty in turning the burners knobs, please contact the After Sales Service for the replacement of the burner tap. Electrical connection The electrical connections must comply with local standards. [. . . ] Before calling the Customer Care Centre, see if the problem you are encountering is mentioned in this guide. Contact the Customer Care Centre to replace the power cable. The burner doesn’t come on or the flame is uneven. Check that: • the gas or electricity supply is not interrupted and, in particular, that the main gas tap at source on the hob, is open; • the gas cylinder has not run out; • the gas outlet openings to the burner have not been obstructed; • the end part of the ignitor isn’t dirty; • all the parts on the burner are properly positioned;there is not a draft near the hob. [. . . ]