User manual WHIRLPOOL KHPF 7520/I PROGRAM CHART

[. . . ] Turn the corresponding control knob anticlockwise until the indicator coincides with the maximum flame symbol . Press the control knob to ignite the burner. Once the burner has lit, keep the control knob pressed for about 5 seconds to allow the safety thermocouple fitted to each burner to engage. The thermocouple will switch off the gas supply to the burner should the flame be accidentally lost ( A gust of air, momentary interruption of gas supply or liquid spillage etc). [. . . ] • Do not let children play with the pan supports. The rubber feet on the underneath of the pan supports could be swallowed by small and cause serious injury or suffocation. • Before replacing the pan supports on the hob, please check that all the rubber feet are in place. • Each time you finish using the hob, always check that the control knobs are in the off position and shut off the tap to the gas mains or cylinder. • Do not obstruct the air vents at the back of the appliance in any way. 8 5019_719_01132_GB 1-06-2007 14:30 Pagina 9 Installation (Flush and Semi-Flush fitting) Technical information for the installer • Warning: this is a heavy products which requires the installation to be carried out by two people. • When installing the hob it is advisable to wear protective gloves. • This appliance can be installed into a 20mm 50mm thick worktop. • If no oven is to be installed below the hob, a panel must be fitted under the hob to prevent hob damage and protect the cupboard contents. This panel must cover the whole of the underside of the hob and must be positioned so that an air gap of at least 50mm between the panel and hob underside is maintained, as a minimum, and as a maximum 150mm to the underneath of the work surface. • This hob is designed to operate perfectly with any oven in the KitchenAid range. The Manufacturer declines all responsibility should any other make of oven be installed. Cut an opening in the worktop to the dimensions shown in the diagram. Carefully place the seal on the external outline of the worktop, as shown in the figure below. Apply a light hand pressure to ensure a good adhesion to the surface. Fix the hob to the unit, using the fixing brackets provided. Note: the electrical power cable must be long enough to allow the hob to be lifted out from above. 10 5019_719_01132_GB 1-06-2007 14:30 Pagina 11 Fixing the Hob to the worktop. Flush fitted model. Important: The following procedure shall be carried out by competent technical personnel only. The hob can be installed on different types of materials, such as masonry, metal, bare wood and heat resistant laminate coated wood (90°C). Cut an opening into the worktop to the dimensions shown in the diagram. • Regulate the minimum levels of the taps. Note: with liquid petroleum gas ( G30/G31) the bypass screw must be screwed in fully. If you then experiance difficulty in turning the control knob, contact our After sales Service though our Customer Care Centre on 00800-3810-4026, who will arrange for a replacement after ascertaining that the tap is damaged. Replacing the injectors Note: Refer to the injector table to ensure the correct type of injector is to be fitted. [. . . ] Note: With time, regular use of the hob could cause some discolouration around the burners. This is caused by the high temperature of the flame and will not affect the operation or performance of the hob. Care and maintenance of the gas burners The pan supports and burners can be removed to make cleaning easier. Hand wash carefully in hot water with a mild detergent making sure that all the ingrained dirt is removed and the openings on the burner are not blocked. The internal burner cap (D), on page 12 is made of brass and is subject to a natural burnishing when it heats up. [. . . ]