User manual WHIRLPOOL KHPF 7520/I/01 PROGRAM CHART

[. . . ] NL GB Instructions for use Product description and symbols Using the burners Practical advice on using the hob Positioning the pan supports and wok support Hood and cabinetry clearances (mm) Injectors table Warnings and suggestions Safeguarding the environment EC Declaration of conformity Installation (Flush and Traditional fitting) Gas connection Electrical connection Fixing the hob to the work top. Traditionally fitted model Fixing the hob to the work top. Flush fitted model Adaption to a different type of gas supply Replacing the injectors Fitting the wok burner Regulating the minimum flow level of the gas taps General cleaning & maintenance Care and maintenance of the gas burners Troubleshooting guide After Sales Service 4 4 5 5 6 6 7 8 8 9 9 10 10 11 12 12 13 13 14 14 15 15 Product description and symbols 1. Professional wok burner control knob Control Symbols Off Maximum flame Minimum flame ! [. . . ] that should not reduce the 100cm2 cross section. - Located in such a position so as not to interfere with the extraction of the products of combustion. Gas connection Connection to the mains gas system must be carried out by a competent, registered person, in compliance with current legislation. • The connection of the hob to the gas mains network or gas cylinder must be done using a rigid copper or steel pipe with parts that comply with local standards, or using a flexible stainless steel pipe with continuous surfaces that comply with local standards. The flexible metallic pipe should be no longer than 2 linear metres. A Gas supply B Gasket C Cooktop Warning: if you use a stainless steel flexible pipe, it must be installed in such a way that it does not come into contact with moving cabinetry like drawers or kitchen cupboards and passes at a point free of obstacles where it can be examined in its entirety. • After connecting to the gas mains, use soap and water to check there are no leaks. 9 Electrical connection The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch. • If damaged, the power cable must be replaced with an identical type of powercable ( H05V2V2-FT90ºC, or H05RR-F type). We recommend that this operation be conducted by our After Sales Service. Please contact our Customer Care Centre on 008003810-4026. • The manufacturer declines all responsibility for damage to persons, pets or goods as a result of failure to comply with the regulations above. L Earth (yellow/green) N Fixing the hob to the work top. Traditionally fitted model Important: The following procedure must be carried out by competent technical personnel only. The hob can be installed on, or into different types of materials, such as masonry, metal, wood and heat resistant laminate coated wood (90°C). Cut an opening in the worktop to the dimensions shown in the figure (Fig. Carefully place the gasket/seal on the external outline of the worktop, as shown in the figure (Fig. Apply a light but firm pressure to ensure a good adhesion to the work surface. Fix the hob using the fixing brackets provided. The appliance is supplied with two types of brackets: - no. 7 standard length brackets (Service code 4812 404 49874) for installation on kitchen tops with thickness over 4 cm - no. 7 long brackets (Service code 4812 404 49875) for installation on kitchen tops with thickness below 4 cm. The brackets must be fixed using the appropriate screws both at the front (no. [. . . ] Clean it each time you use it with a product specifically designed for brass. Use hot water and a mild deteregent to clean the the wok burner external cap (item (C) on page 12). Never use harsh products, or scouring pads that will damage the special surface coverings. Correctly refit the burners and caps in their place. [. . . ]