User manual WHIRLPOOL KHRT 6020 INSTRUCTION FOR USE

[. . . ] Instructions for use Important instructions for safety Installation Safeguarding the environment Troubleshooting guide After-Sales Service Cleaning Maintenance Material supplied Installation - preliminary assembly instructions Installation dimensions Installation - assembly instructions Description and use of hood 4 5 6 6 7 7 8 9 10 11 12 13 Important instructions for safety YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. • The appliance is not intended for use by people (children included) with physical, sensory or mental impairment or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety. • Do not repair or replace any part of the appliance unless specifically indicated in the manual. [. . . ] • Make sure the lamp is correctly fitted. Fig. 4 6 After-Sales Service Before calling the After-Sales Service: 1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide". Switch the appliance off and back on again it to see if the fault persists. If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service. Always specify: • A brief description of the fault; • The exact type and model of the appliance; • The service number (number after the word "Service" on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet; • Your full address; • Your telephone number. If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly). Cleaning WARNING • Do not use steam cleaners. • Disconnect the appliance from the power supply. IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters, checking correct installation and hooking, otherwise the hood will not switch on. IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it immediately with a damp cloth. • Clean the surfaces with a damp cloth. If very dirty, add a few drops of washing up detergent to the water. Dry with a dry cloth. IMPORTANT: Do not use abrasive sponges, metallic scrapers or scouring pads, as they could eventually spoil the enamelled surfaces. • Use specific detergents for cleaning the appliance and follow the manufacturer's instructions. IMPORTANT: Clean the filters at least monthly to remove any oil or grease residuals. IMPORTANT: Failure to carry out correct hood cleaning or filter maintenance involves the risk of fire. Therefore make sure to follow the instructions. The manufacturer declines any liability for damage to the extraction unit, fires caused by improper maintenance or failure to observe the above instructions. 7 Maintenance WARNING • Use protective gloves. • Disconnect the appliance from the power supply. IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters, checking correct installation and hooking, otherwise the hood will not switch on. GREASE FILTER Its purpose is to retain the particles of grease produced by cooking. It must be cleaned once a month (or when the filter saturation warning system indicates this need) with non-aggressive detergents, by hand or in a dishwasher at low temperature and with short cycle. [. . . ] Operation times are as follows: • extraction speed (power) 1: 20 minutes. • extraction speed (power) 2: 15 minutes. • extraction speed (power) 3: 10 minutes. • extraction speed (power) 4: 5 minutes. Fig. [. . . ]