User manual WHIRLPOOL KRCB 6040 INSTALLATION

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. nstallation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. Safeguarding the environment 1. [. . . ] The acoustic signal can be deactivated by pressing the button (11) on the control panel. Place food in the freezer only when the red alarm light has gone off. Note: • 4-5 hours are required for the refrigerator compartment to reach a temperature suitable for storage. • Ambient temperature, frequency of door opening and position of the appliance can affect the temperature inside the two compartments. These factors should be taken into account when setting the thermostat position. • The space between the shelves and the rear wall of the refrigerator ensures the free circulation of air. • Do not place food in direct contact with the rear wall of the refrigerator compartment. • Do not place hot food in the compartments. • Store liquids in closed containers. • Storing vegetables with high water content can cause condensation to form: this does not affect correct appliance operation. Storing food in the refrigerator compartment Place the food as shown in the figure. Removing the baskets Pull the drawers out as far as they go, then lift slightly and remove. Note: The freezer can also be used without drawers, in order to obtain a larger space. After introducing the food make sure the freezer compartment door closes properly. Making ice cubes • Fill the ice cube tray up to 2/3 with water and place in the freezer compartment. • Do not use sharp or pointed objects to detach the tray if it is stuck to the bottom of the freezer grill or drawers. • Bend the ice tray slightly to facilitate removal of the cubes. 10 Maintenance and cleaning Before carrying out any cleaning or maintenance operation, switch the product off by pressing button (1) on the control panel for 3 seconds, then unplug the appliance or disconnect it from the power supply. Cleaning the freezer compartment Defrosting of the freezer compartment is completely automatic. If you wish to clean the compartment, switch the appliance off as previously indicated and proceed as follows: 1. Open the freezer door and remove all the food, wrapping it close together in sheets of newspaper and put in a very cool place or in a portable cooler. Clean the inside of the freezer with a sponge soaked in a solution of lukewarm water and/or mild detergent. Reconnect the appliance to the power supply and press the button (1) again for 3 seconds. [. . . ] Should the display not go off when the door is correctly closed, contact the Customer Care Centre. • First check point 1, then: - Disconnect the appliance from the power supply. To access the lamp refer to the instructions and diagram on the attached product sheet. - Check the lamp and, if necessary, replace it with a new one (available only from the Customer Care Centre). [. . . ]