User manual WHIRLPOOL KRDD 9010 INSTALLATION

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. Safeguarding the environment 1. [. . . ] The Manufacturer declines any liability if the above advice and precautions are not respected. • Make sure the voltage specified on the rating plate corresponds to that of your home. • Do not use single/multi adapters or extension cords. • For the water connection, use the pipe supplied with the new appliance; do not reuse that of the previous appliance. • Power cable modification or replacement must only be carried out by qualified personnel. • It must be possible to disconnect the appliance from the power supply by unplugging it or by means of a mains two-pole switch installed upstream of the socket. 5 Installation • Install the appliance away from heat sources. Direct exposure to sunlight or installation near heat sources (radiators, cookers) will increase energy consumption and should therefore be avoided. • If this is not possible, the following minimum distances must be respected: - 30 cm from coal or oil stoves; - 3 cm from electric and/or gas cookers. • Clean the inside (refer to “Maintenance and cleaning” of the appliance). • Insert or install the accessories/parts supplied. Using the product This appliance is an electronically controlled, drawers refrigerator for the storage of fresh food and beverages. Refrigerator compartment defrosting is completely automatic. Optimum performance depends on the climatic class indicated on the rating plate. Settable temperature limit: • +3°C coldest temperature • +8°C warmest temperature Fast cooling function (“Fast Cooling”) The use of this function is recommended when placing a very high quantity of food in the refrigerator compartment. By pressing the button (10) it is possible to increase the cooling speed of the foods inside the refrigerator compartment. The function is automatically deactivated after 6 hours. In any case, the “Fast cooling” function can be manually deactivated by pressing the same button (10). Switching the refrigerator off Press the button (1) for 3 seconds. The “--” sign will replace the temperature value on the display. To reactivate the refrigerator, press the same button (1) for 3 seconds. 7 Using the product Appliance’s alarms Open drawer alarm (upper draw only). The acoustic alarm will activate when the upper drawer has been left open. Pressing the Acoustic Alarm button (6), will silence the alarm. To completely deactivate the drawer open alarm, close the refrigerator drawer. Temperature alarm An increase in temperature inside the appliance, over +15°C, with the drawers closed, will cause the alarm to sound and a red warning LED (5) to flash. [. . . ] • Making sure the bottles and containers are not touching each other. Some possible operation noises: • Hissing when the appliance is switched on for the first time or after a long period. • Gurgling when the refrigerant enters the pipes. • Humming when the water valve or fan are activated. [. . . ]