User manual WHIRLPOOL KRSC 9005 KA PRODUCT FICHE

[. . . ] Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer’s instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. Safeguarding the environment 1. [. . . ] • The buttons and control panel display (located on the freezer door on some models) must be cleaned with a dry cloth; do not use alcohol or alcohol-derived substances. • The refrigerant system pipes are located near the defrost pan and can become very hot. Periodically clean them with a vacuum cleaner. Replacing light bulbs Attention • Always disconnect the refrigerator from the power supply before replacing any light bulbs. • Before replacing the light bulb, remove the light guard that may be present. This will have to be put back after replacing the light bulb. • The refrigerator accepts light bulbs with a bayonet type mount. • The ice/water dispenser light bulb has a standard screw type mount. Replace the lamp with one of the same type, available from the After-sales Service or from authorised dealers. 7 Guide to the inside parts CRISPER AND MEAT DRAWER Removing the crisper or meat drawer: 1. slide the drawer out as far as it goes; 2. with one hand underneath the drawer, lift and pull it out; 3. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small amount of crushed ice may come out together with the first cubes. The quantity and size of the ice cubes depend on the mains water pressure. Ice cubes production can be increased by decreasing the temperature on the freezer compartment. ONLY FOR MODELS FITTED WITH ICE DISPENSER Normal ice production consists of about 12 to 14 batches of ice cubes in a 24-hour period. To remove and replace the ice container Insert your fingers in the opening at the bottom of the container, pull the lever and lift and extract the container. For some models, to remove the container insert your fingers in the opening at the bottom of the container, place your thumb on the release button and lift at the same time. To replace the ice container in its place, place it on its support attached to the inner door and lower in position. Note: Large amounts of ice cubes should be taken directly from the bucket, and not from the dispenser. 9 Storing, freezing and thawing food INTRODUCTION Wrap food so that no water, moisture or condensate can enter; this will prevent odours or aromas going from one part to another in the refrigerator, ensuring better preservation of frozen foods. Use plastic containers with hermetic lids, aluminium trays, aluminium foil, plastic film and waterproof plastic wraps. NOTE: Never place hot food in the freezer. [. . . ] • Is the ice bucket correctly installed?If the ice dispenser stops working: • Are the ice cubes stuck because the ice dispenser has not been used for some time?Shake the ice bucket to separate the cubes and increase the holding capacity. It is advisable to throw away the old ice cubes and make new ice. [. . . ]