User manual WHIRLPOOL KRSC - 9020 I INSTALLATION

[. . . ] KRSC 9011/1 KRSC 9006 KRSF 9005/SL KRSF 9005/BL Assembly instructions Before installing the refrigerator Water connection Electrical connection Positioning and levelling your refrigerator Installation dimensions and requirements Removing the freezer door (A) Removing the refrigerator door (B) Fitting the freezer door (C) Fitting the refrigerator door (D) Horizontal alignment of freezer and refrigerator door (E) Vertical alignment of freezer and refrigerator door (F) 4 4 5 6 7 8 8 9 9 10 10 Before installing the refrigerator Your new appliance is a FULL NO FROST model exclusively for domestic use, i. e. both refrigerator and freezer compartments are provided with an automatic defrosting function. [. . . ] • Remove the packing tape from the grey coiled water pipe on the back of the product. • Connect the transition connector (1) to the household water supply (2). • Make sure the water pipe is not twisted. • The appliance is pre-set for operation at pressures between 0. 17 and 0. 81 Mpa (1. 7 and 8. 1 bar). • The appliance does not require any adjustment or water drain. 4 Electrical connection Earthing of the appliance is compulsory by law. The type of current and the mains voltage to which the appliance is connected must correspond to that given on the rating plate. The connection socket must be accessible even after installation, so that the appliance can be unplugged if necessary. If this is not possible, connect the appliance to the mains by means of a two-pole switch, with contact opening distance of at least 3mm, located in an accessible place. If the power cable plug and socket are not of the same type, replace the socket. Do not pull the power cable when unplugging the appliance. 5 Positioning and levelling your refrigerator The refrigerator has two front wheels and two rear wheels at the base of each product on each side, and two adjustable feet at the front (see figure A). [. . . ] Note: Do not unscrew the levelling bolts and the feet too much as they could fall out. Aligning the doors If after switching on the appliance and adjusting the refrigerator and freezer doors, the doors are misaligned, disconnect the appliance from the power supply and adjust both doors as indicated in the diagram at the end of this manual. Figure A Figure B 6 7 8 9 10 Printed in Italy 03/08 n GB 5019 102 00382 [. . . ]