User manual WHIRLPOOL KRSF 9005/SL INSTALLATION

[. . . ] The model you have purchased may differ slightly with respect to some descriptions in this manual, since this manual covers several models. Keep this manual for future consultation. If you sell the appliance give it to the new buyer. [. . . ] • Connect the transition connector (1) to the household water supply (2). • Make sure the water pipe is not twisted. • The appliance is pre-set for operation at pressures between 0. 17 and 0. 81 Mpa (1. 7 and 8. 1 bar). • The appliance does not require any adjustment or water drain. 4 Electrical connection Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the prescriptions. Make sure that the installation and the electrical connection are carried out by a qualified technician according to the manufacturer’s instructions and local safety regulations. If your new appliance, supplied in accordance with current regulations, is provided with a plug with no earth wire, connect your green/yellow earth wire (A) to the earth screw located on the appliance (B) (see figure). This operation should only be carried out by qualified personnel. Ensure that the voltage indicated on the appliance data plate corresponds to the mains voltage. The plug of the appliance must be easily accessible even after installation so that the appliance can be unplugged if necessary. It must be possible to disconnect the appliance from the power supply by unplugging it or by means of a mains double-pole switch installed upstream of the socket. If the power supply cable plug and socket are not of the same type, replace the socket. After installation, make sure that the appliance is not standing on the power supply cable. Disconnect the appliance from the power supply by unplugging it. [. . . ] Turn the levelling bolt clockwise to raise the appliance, or anti-clockwise to lower it. It may take several turns of the levelling bolts and/or the feet to adjust the tilt of the refrigerator. After adjusting the level ensure that both feet touch the floor to ensure safe operation. [. . . ]