User manual WHIRLPOOL KRSM 9005 PRODUCT FICHE

[. . . ] Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer's instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. Safeguarding the environment 1. Packing The packing material is 100% recyclable and bears the recycling symbol. [. . . ] • Do not eat ice cubes or ice lollies immediately after taking them out of the freezer since they may cause cold burns. USE • Before carrying out any maintenance or cleaning operation, unplug the appliance or disconnect it from the power supply. • All appliances equipped with an automatic icemaker and water dispenser must be connected to a water supply that only delivers drinking water (with mains water pressure of between 0. 17 and 0. 81 Mpa (1. 7 and 8. 1 bar)). Automatic ice-makers and/or water dispensers not directly connected to the water supply must be filled with drinking water only. • Use the refrigerator compartment only for storing fresh food and the freezer compartment only for storing frozen food, freezing fresh food and making ice cubes. • Do not store glass containers with liquids in the freezer since they may burst. The Manufacturer declines any liability if the above advice and precautions are not respected. Electrical connection for Great Britain and Ireland only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. • The ice and water dispenser light, if present, is a normal screw bulb. Only use bulbs of the same type which can be requested from the After-sales Service and authorized dealers. Cleaning, sanitization and maintenance of the ice and/or water dispenser (if present) Failure to follow the instructions regarding sanitizing can compromise the hygienic safety of the water dispensed. • When using the appliance for the first time, discard the first 9-14 litres of water, equivalent to 6-7 minutes of dispensing (not necessarily consecutive, but before initial consumption) and discard the ice produced in the first 24 hours. • Reposition the removable water dispenser (if present), ensuring your hands are hygienically clean. • Periodically clean the ice bucket or drawer under running water only. • Every six months, sanitise the water and ice dispensing system with disinfectant solutions (sodium hypochlorite based) suitable for materials in contact with food and which do not alter the characteristics of the materials. • Replacement of any parts of the ice and water dispenser must be carried out using original spare parts provided by the Manufacturer. • Any work on the appliance must be carried out by a qualified technician or the After-sales Service. 8 Using the ice and water dispenser (where provided) For connection to the mains water supply see the Installation manual. To dispense water: Water delivery is always available. Press a glass against the water dispenser lever. Water delivery stops when the lever is released. [. . . ] slide the drawer out as far as it goes; 2. with one hand underneath the drawer, lift and pull it out; 3. the drawer will come out of its runners and can be pulled out further; 4. to remove it completely, the drawer must be tilted: front end up, back end down. [. . . ]