User manual WHIRLPOOL KRSM 9030 INSTRUCTION FOR USE

[. . . ] Instructions for use Before using the appliance Safeguarding the environment Precautions and general recommendations Electrical connection for Great Britain and Ireland only First use When the appliance is not used Appliance maintenance and cleaning Cleaning, sanitization and maintenance of the ice and/or water dispenser (if present) Using the ice and water dispenser (where provided) Using the automatic ice maker (where provided) Storing, freezing and thawing food “MULTIFLOW” air system (where provided) Guide to internal components Changing a water filter cartridge (where provided) After-sales service 4 4 5 6 7 7 8 8 9 10 11 11 12 13 14 Before using the appliance • This appliance is intended to be used in household and similar applications such as - staff kitchen areas in shops, offices and other working environments; - farm houses and by clients in hotels, motels and other residential type environments; - bed and breakfast type environments; To ensure best use of your appliance, carefully read the operating instructions which contain a description of the product and useful advice. Keep these instructions for future reference. After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. [. . . ] approved fuse to BS 1362 type and proceed as follows: 1. Fit replacement 13A fuse into fuse cover. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact KitchenAid Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified technician in compliance with the manufactures instructions and current standard safety regulations. 6 First use When the appliance is connected to the power supply, the display will show the factory preset temperatures (-18°C and +5°C). If the acoustic signal sounds and the temperature indicator blinks, press and hold the alarm mute button. Note: After being switched on, the appliance needs approximately 2/3 hours to reach the correct temperature to store a typical volume of food. As applicable, insert the anti-bacterial and anti-odour filter as indicated on the filter package. When the appliance is not used Disconnect the appliance from the power supply. Empty the appliance and leave the doors open just enough to allow air to circulate inside the compartments. This will prevent the formation of mould and bad odours. If your appliance has an automatic ice maker: 1. Shut off the water supply to the product. DURING BLACKOUTS For power failures lasting up to 12 hours, keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible. Should the power failure last more than 12 hours, remove all food from the product and store it in a suitable appliance. 7 Appliance maintenance and cleaning Periodically clean the appliance with a new cloth and a solution of lukewarm water and neutral detergent specific for cleaning the inside of the refrigerator. Clean the condenser using a vacuum cleaner, after removing the front plinth (see Installation manual). The buttons and control panel display (in some models, located on the freezer door) must not be cleaned with alcohol or alcohol-derived substances, but with a dry cloth. [. . . ] Meat / crisper drawer temperature control (where provided) • The cold air is conveyed inside the meat drawer through an opening between the refrigerator compartment and the freezer compartment. In this way the temperature inside the meat drawer is kept lower than the rest of the refrigerator. The air flow can be adjusted by means of the special slider. • If you wish to store vegetables in the meat drawer, shift the control all the way to the left, to the fruit/vegetables setting. [. . . ]